CRA TE
THE REAR PANEL:
DAMAGE TO THE AMPLIFIER MAY OCCUR.
DC CHARGERDC CIGARETTE
PLUGLIGHTER ADAPTOR
LIT WHEN
CHARGING
15V DC12V DCPOSITIVENEGATIVE
2526
25. DC CHARGER PLUG, 15VDC: Plug the26. DC CIGARETTE LIGHTER ADAPTER, 12
small round connector of the supplied ACVDC: Plug the small round connector of the
wall adapter into this jack to charge theoptional 12-volt car adapter into this jack to
internal battery. The LED next to the jackplay the amplifier from a vehicle, without
glows red when the amp is charging. Seeusing the internal battery. NEVER connect
page 4 for additional information. the supplied 15-volt charger to this jack!
See page 4 for additional information.
ABOUT THE INSERT JACK:
The Insert jack (#8) lets you patch external effects into the amplifier just prior to its power amp
stage, as shown below. Set the mix controls on the external effects units to Ofull effect� (100% wet).
Connecting to the effectOsConnecting to the effect with aConnecting to the effect with a
insert jack with a stereo cable:stereo-to-mono Y-cable:stereo-to-mono adapter and cables:
TOTIP: LINE IN (RETURN)TOTIP: LINE IN (RETURN)TOTIP: LINE IN (RETURN)
INSERT,RING: LINE OUT (SEND)INSERT,RING: LINE OUT (SEND)INSERT,RING: LINE OUT (SEND)
TX50DSLEEVE: GROUNDTX50DSLEEVE: GROUNDTX50DSLEEVE: GROUND
STEREO 1/4" TO
CYC6MS
STEREO 1/4" CABLEDUAL MONO 1/4" TOCA11Y
STEREO 1/4" Y-CABLEDUAL MONO 1/4" TO
STEREO 1/4" ADAPTER
MONO 1/4" TO
(IF EFFECT IS NON-INVERTING)MONO 1/4" CABLES
(IF EFFECT IS INVERTING)
LINE IN (RETURN)LINE OUT (SEND)
TOTOFROMTOFROMTO
STANDARDINVERTEDMONOMONOMONOMONO
INSERT,INSERT,OUTPUT,INPUT,OUTPUT,INPUT,
EFFECTEFFECTEFFECTEFFECTEFFECTEFFECT
8 |