Power supply
Using on batteries
Open the lid of the battery compartment on the rear and
OPE/BATTinsert eight R14 (size C) batteries, not supplied, as
illustrated below. Then close the lid.
To switch from AC power supply to battery supply,
disconnect the AC cord from the AC inlet.
The OPE/BATT indicator lights up while the power is
on.
R14 (C)
Using on AC house current
YWhen using the unit on the batteries, the display light
Connect the AC cord as illustrated below.
is out.
When the OPE/BATT indicator becomes dim, volume
decreases, or sound is distorted during operation,
replace the batteries.
When the batteries become weak during tape
operation, OLo� flashes in the display. In stop mode, the
unit will not accept w REC, e PLAY/PAUSE, f1 to the AC inlet of
and g. In playback or recording mode, the unit will be
the unit
stopped and turned off.
2 to an AC outlet Replace the batteries.
supplied AC cord(AC 120 V, 60 Hz)
Notes on batteries
Y The rated voltage of the unit is 120 V AC.To avoid damage from leakage or explosion, observe
YIf abnormal high voltage is supplied, OHi� flashes inthe following:
the display and the unit does not accept anyYInsert the batteries with the 0 and 9 marks correctly
operation. Disconnect the AC cord.aligned.
YDo not mix different types of batteries or old batteries
CAUTIONwith new ones.
Use only the supplied AC cord. Use with other cordsYWhen the unit is not to be used for a long period,
may result in the risk of fire.remove the batteries.
YNever recharge the batteries, apply heat to them or
take them apart.
YRemove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to
remove.
Maintenance
To clean the cabinetAfter every 10 hours of use, clean the tape heads
Use a soft cloth lightly moistened with mild detergentwith a head cleaning cassette.
solution. Do not use strong solvents such as alcohol,Use separately sold dry-type or wet-type cleaning
benzine or thinner.cassette.
Refer to the instructions of the cleaning cassette for
To clean the headsdetails.
When the tape heads are dirty;Lens
- high frequency sound is not emittedTo clean the lens
- the sound is not adequately highUse a cotton swab slightly
- the sound is off-balancemoistened with cleaning
- the tape cannot be erasedfluid. Wipe gently from the
- the tape cannot be recorded oncenter to the edge.
4 ENGLISH |
ACEC
AIWA
