CV OM 9/28/05 12:50 PM Page 5
¨¨
DOLBYDIGITAL OR DTS
(OR OTHER DIGITAL SURROUND MODE) CONNECTION
Frequency Effects channel.your receiver for 5.1-, 6.1-
Connect this jack to the LFEor 7.1-channel operation as
output or subwoofer output appropriate. The front left,
on your receiver or amplifier.front right, center and rear
Connect each speaker to speakers should all be set
the corresponding speaker to OSmall.� If your receiver
Use this installation method
terminals on your receiver allows you to set the cross-
for Dolby Digital, DTS or
or amplifier.over frequency between the
other digital surround
Make sure that you havesubwoofer and the main
processors: speakers, select 100Hz or
configured your surround
Use the line-level input jackthe setting that is the closest
sound processor for OSub-
marked OLFE� for the Low-frequency below it.
woofer On.� Also configure
DOLBY PRO LOGIC¨(NON-DIGITAL) � LINE LEVEL
Use this installation methodUse RCA-type interconnectsNOTE: If your receiver or
for Dolby Pro Logic applica-to connect the line-level amplifier has only one sub-
tions (not Dolby Digital, DTSsubwoofer outputs on yourwoofer output jack, then you
or other digital processing),receiver or amplifier to thewill need to use a Y-connector
where the receiver/proces-line-level inputs on the sub-(not included). Plug the male
sor is equipped with a sub-woofer. IMPORTANT: Do notend of the Y-connector into
woofer output, or a volume-use the LFE input on the sub-your receiver or amplifierOs
controlled preamp (line-)woofer with Dolby Pro Logicsubwoofer output jack, and
level output:processors. connect each of the two
female ends to separate
RCA-type interconnects.
Finally, plug the RCA-type
interconnects into the line-
level inputs on the sub-
woofer.
Connect each speaker to
the corresponding speaker
terminals on your receiver
or amplifier.
Make sure your receiver or
processor is correctly con-
figured to indicate that the
subwoofer is OOn.�
5
5
LFEOUTRECEIVERLINELEVELINLFELRSUBWOOFER |
ACEC
JBL
