INSTALLATION
Installation
Television LocationCable / Antenna Connection
This unit is intended to be used with an optional stand orFor proper reception, either a cable or antenna connection
entertainment center. Consult your dealer for availableis required.
options.Cable ConnectionIncoming Cable from
?Avoid excessive sunlight or bright lights, includingCable Company
Connect the cable supplied by your local
reflections.cable company. Tighten with fingers only.
?Keep away from excessive heat or moisture. Inadequate
Use of any tool (e.g. pliers) for tightening
ventilation may cause internal component failure.may result in tuner damage.
?Fluorescent lighting may reduce remote control
Note: A cable converter box may be75 Ohm VHF/UHF
transmitting range.required for proper reception.on back of TV
?Keep away from magnetic equipment, including motors,
Check with your local cable
fans and external speakers.company for compatibility requirements.
WARNING: Use this television receiver only with theAntenna Connection
cart, stand, tripod, bracket, or table specified by the
ENGLISH?For proper reception of VHF/UHF channels, an
manufacturer, or sold with the apparatus. When a cart
is used, use caution when moving the cart/apparatusexternal antenna is required. For best reception an
outdoor antenna is recommended.
combination to avoid injury from tip-over. In order to
avoid injury to children, never place your television receiver on a?Connect home antenna toIncoming Cable from
ANT connection on back ofHome Antenna
piece of furniture that is capable of being tilted by a child leaning
on it, pulling on it, standing on it, or climbing on it. A fallingtelevision. Select TV mode in
the SET UP menu.
television can cause serious injury or even death.
Note: Cable Mode is preset at the
CT-32HC15, CT-32HC15U:
factory. Antenna users must
CAUTION: These television receivers for use only withchange to TV Mode in the Set
PANASONIC TY-32SC15T stand. Use with other cartsUpmenu (page 15).
(or stands) is capable of resulting in instability causingRemote Control Battery Installation
possible injury.
Requires two AA batteries (supplied).
CT-32HL15, CT-32HL15U: Battery Polarity
CAUTION: These television receivers for use only with
PANASONIC TY-32HL15T stand. Use with other carts
(or stands) is capable of resulting in instability causing
/ 1.5AAA
possible injury.
AA / 1.5A
Optional Cable Connections12
Shielded audio and video cables should be used between
components. For best results:
?Use 75-ohm coaxial shielded cables.
?Use appropriate input and output connectors, that match / 1.5AAA
AA / 1.5A
your component connectors.
?Avoid long cables to minimize interference.3
AC Power Supply Cord
CAUTION: TO PREVENT ELECTRIC SHOCK,Procedure
MATCH WIDE BLADE OF PLUG TO WIDE SLOT
OF AC OUTLET AND FULLY INSERT. DO NOT1. Turn the remote control face down. Remove batteryPolarized plug
cover by pressing down on the marking on the cover
USE A PLUG WITH A RECEPTACLE OR OTHERand sliding it off in the direction indicated.
OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO
2. Install batteries matching (+) and (-) polarity signs.
PREVENT BLADE EXPOSURE.
PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED3. Replace the battery cover by sliding in reverse until the
lock snaps.
OVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS,
CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXITNote: Incorrect installation can cause battery leakage and
corrosion that will damage the Remote Control.
FROM THE APPARATUS.
Precautions
?Replace batteries in pairs.
?Do not mix battery types (zinc carbon with alkaline).
?Do not recharge, heat, short-circuit, disassemble, or
burn batteries.
4 z |
ACEC
PANASONIC
