CV OM 5/14/04 3:37 PM Page 6
MOUNTING THE SATELLITES ON OPTIONAL FLOOR STANDS
Important Safety Note:Prepare the speaker wire
The supplied floor standas described on page 8, and
adaptors facilitate installationthread it through the floor
with a variety of general-standOs wire management
purpose floor stands availablesystem (if any), as instructed
from many manufacturers.in the ownerOs guide for the
Since different stands willstands. Make sure to pre-
have different weight capaci-serve the proper polarity
ties and stability characteris-(+ and � connections).
tics, it is the customerOsUse the supplied terminal
responsibility to check withwrench to loosen the red col-
the stand manufacturer orlar of the binding post until
dealer to ascertain whetherthe pass-through hole under-
that specific stand is capableneath it is revealed. Insert the
of handling the weight andbare end of the positive wire
proportions of these loud-through the hole, then screw
speakers in a safe and stablethe collar down until it is
manner. JBL disclaims anytight. Follow the same proce-
liability for the selection dure to connect the negative
of suitable floor standswire to its terminal.
and/or correct compatibility
between the selected standSlowly lower the mounting
bracket on the satellite onto
and the supplied stand the top of the floor stand
adaptor.
adaptor until the metal spring
The floor stand adaptors areclip engages in the squarish
compatible with floor standsopening on the front of the
equipped with a 1/4"-20adaptor.
threaded insert.Gently pull the slack out of
Using a suitable bolt suppliedthe wire, and slide the floor
with the stand (or by you),stand cover over the adaptor
attach the floor stand adaptorfor a smooth appearance.
to the stand by screwing the
bolt through the hole in the
bottom tab of the adaptor and
into the threaded insert at the
top of the stand. Orient the
adaptor so that the upright
portion faces toward the
listening position.
6 |