How to Empty Dust CaseMaintenance
Dust case filters (Required maintenance once a month)
Close the lid of dust case until the button clicks.
3Click(The filters are washable.)
Press the
Remove the dust case and empty the dust.The base of
1button
Dust casecyclone chamber
5
1) Turn the dust case upside-down, press the
Lid of dust casebutton with thumb,
2
Cyclone chamber
2) Remove the cyclone chamber by pulling the
Push the dust case into the
base of cyclone chamber with two fingers
cleaner body firmly so that there(the forefinger and the middle finger).4
is not a gap between the lid of the3) Remove the dust around the inside meshInside mesh
dust case and cleaner body.filter. (The mesh filter is washable.)filter
Open the lid of the dust case and remove theThe base of
3mesh filter, you can wash the mesh filter,cyclone chamber
urethane filter, black filter and under mesh
filter with water.
Dust caseBody
Dust case
Mesh
Transparent
filterMesh filter
Close the top cover until the button clicks.case cover
5Urethane filterUnder mesh
Clickfilter
Black filter
Note : Black filterUnder mesh filter
�Please be careful not to be put your fingers between theLid of the dust case
top cover and dust case.Urethane filter
Return the lid of dust case to the
4original position until it clicks and put
the base of cyclone chamber on the
Click
Å°The base dust case. Align the mark of the
of cyclone
base of cyclone chamber to the Å°
Å°mark
Maintenancechamber
mark of the dust case.
ů?d??
Install the dust case into cleaner
Dust case
5body.
Warning :6
Before maintaining, the mains plug should be removed from the mains socket.Lid of the dust case
Note :
�Be sure to set each filter in its correct position firmly, otherwise suction
power will be decreased.
Filter maintenance sign
HEPA clean filter (Required maintenance once a month) �When suction power is weak, the operation noise level is higher and the filter maintenance sign
operates, the dust case should be emptied and the filters cleaned (inside mesh filter and under
(The HEPA clean filter is not washable.)
mesh filter).
Remove the HEPA clean filter from the
1dust case as shown in the illustration.
HEPA clean
Remove dust around HEPA cleanfilter
2filter by patting it gently.
HEPA clean
filter
Knob
When the orange indicator appears in the window continuously, the cleaner requires emptying.Reinstall the HEPA clean filter into
3dust case with grips facing the upward.
Check the dust indicator by lifting suction tool from the floor and removing the crevice nozzle when it
is used.Notes :
�Only pat the filter gently. If you pat it strongly, its shape may be changed and this will cause dust leakage.
Note :
�Do not use a brush with hard bristles , it may cause damage to the filter.
�If the cleaner is used in such a condition that the orange indicator appears in the window, air to the motor
�Make sure that the HEPA clean filter is seated correctly. Otherwise you cannot install the dust case correctly.
will be reduced and the motor will eventually burn out.
If you use the cleaner without HEPA clean filter, it will eventually cause motor failure. |
ACEC
HITACHI
