1Connect the bare ends of each speaker cord toYDo not connect other equipment to the TO TS-LW700UThe automatic demonstration will run on the display while
the corresponding speaker.jack because this is used exclusively for the suppliedthe power is turned off.
Be sure to use the correct cord for each speaker.subwoofer.To deactivate the automatic demonstration, press DEMO/
- Front speaker cords have bare leads at both endsECO. The clock will flash on the display. For setting the
6Connect the supplied antennas.
(approx. 4 m / 13 ft.).clock, see page 13.
Connect the FM antenna to the FM 75 & terminals and
- Surround speaker cords are the longer cords with a plugYDo not short-circuit the 0 and 9 speaker cord leads.
the AM antenna to the AM LOOP terminals.
at one end (approx. 8 m / 26 ft.).YDo not leave objects generating magnetism or objects
The red plug is for the right channel and the white plugaffected by magnetism near the speakers.EnFM antenna
is for the left channel.
- Center speaker cord is the short cord with an orange
Remote control
plug at one end (approx. 3 m / 10 ft.).
The copper-colored cords go to the 0 terminal of eachWhile sliding the latch, pull out the battery holder from the
speaker.bottom of the remote control. Place the supplied battery on
the battery holder with correct polarity. Finally, insert the holder
2Connect the cords from the front speakers to theback into position.
appropriate terminals on the subwoofer.
- Right front speaker: FRONT R terminals
AM antenna
- Left front speaker: FRONT L terminals
The copper-colored cords go to the 0 terminals.
7Connect the television set.
If your TV set has an S-video input jack:
Connect the S-VIDEO OUT (S1) jack of this unit and the
S-video input jack of your TV with an optional S-video
connecting cord.YReplace the battery with a new one when the operational
If your TV set does not have an S-video input jack:distance between the remote control and main unit becomes
Connect the VIDEO OUT jack of this unit and the videoshorter.
input jack of your TV with the supplied video connectingYRemove the battery if the unit is not going to be used for an
cord (the one with plugs at both ends).extended period of time.
3Connect the cords from the surround speakersRefer also to the Operating Instructions of your TV set.YThe remote control may not operate if it is used under intense
to the appropriate jacks on the subwoofer.The illustration shows the connection to the VIDEO OUTsunlight or if its line of sight is obstructed.
- Right surround speaker: SURROUND R jack (red)jack.
- Left surround speaker: SURROUND L jack (white)YIf your TV set is a wide-screen set: you need to adjustCaution!
the TV aspect setting later (see OTV Aspect�, page 33).YDo not keep the battery near metallic objects such as rings,
4Connect the cord from the center speaker to the
YDo not use more than one connection to connect yourbracelets, and keys. It may cause the battery to short circuit.
CENTER jack (orange) on the subwoofer.
TV.YAfter removing the battery, be sure to keep it out of reach of
children. In case it is swallowed, consult a doctor
5Connect the subwoofer to the main unit.
8Connect the power supply.immediately.
Connect the FROM CX-LDV700U jack of the subwoofer
Plug in the AC power cords of the main unit and the
to the TO TS-LW700U jack with the supplied connecting
subwoofer to AC outlets.
cord (DIN 8-pin).
7 |
ACEC
AIWA
