9. Color Reproduction Adjustment
Adjust the color Separation matrix coefficient so that proper color
reproduction is produced.
SubjectColor bar chart
(Color reproduction adjustment frame)
Measurement PointVideo output terminal
Measuring Instrument VectorscopeFor NTSC model
Adjustment PageF
Adjustment Address35, 37, 3C, 3D
Specified ValueAll color luminance points should
settle within each color reproduction
frame.
Note:NTSC model: DCR-PC100
PAL model: DCR-PC100E
Switch setting:
1) POWER.................................................................. CAMERA
2) NIGHT SHOT ..................................................................OFF
3) DIGITAL ZOOM (Menu display) ...................................OFF
4) STEADY SHOT (Menu display) .....................................OFF
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.Burst position
2) Select page: F, address: 8E, set data: 14, and press the PAUSE
button of the adjustment remote commander.
3) Select page: F, address: C0, set data: 37 (NTSC) or B7 (PAL),
and press the PAUSE button.
4) Select page: 6, address: 01, set data: 3D, and press the PFor PAL modelAUSE
button.Burst position
5) Adjust the GAIN and PHASE of the vectorscope, and adjust
the burst luminance point to the burst position of the color
reproduction frame.
6) Change the data of page: F, address: 35, 37, 3C and 3D, and
settle each color luminance point in each color reproduction
frame.
Note:Be sure to press the PAUSE button of the adjustment remote
commander before changing the addresses. If not, the new data
will not be written to the memory.
Processing after Completing Adjustments:
1) Only for the NTSC model, select page: F, address: 8E, set data:
17, and press the PAUSE button of the adjustment remote
commander.
2) Select page: 6, address: 01, set data: 00, and press the PAUSE
button.
3) Select page: 0, address: 01, and set data: 00.
Fig. 5-1-11
5-26 |
ACEC
SONY
