1-1-2. Preparations
Note1: For details of how remove the cabinet and boarO2.ds, refer to
DISASSEMBLY �.
Note2: When performing only the adjustments, the lens block and boardsPattern box
need not be disassembled.
Note3: Before performing the adjustments, check the data of page: 0,
address: 10 is O00�. If not, set data: 00 to this address.
100 cm (PTB-450)
1) Connect the equipment for adjustments according to Fig. 6-1-3.40 cm (PTB-1450)
Note4: As removing the control switch block (ZM11600) (removing the
VC-380 board CN1001) means removing the lithium 3V power
supply (ZM11600 block, BT8601), data such as date, time, user-
set menus will be lost. After completing adjustments, reset these
data.
But, the self-diagnosis data and the data on history of use (totalFront of the lens
drum rotation time etc.) will be kept even if the ZM11600 block
has been removed. (RefO6-4.Service Modeer to � for the data on
the history use and the self-diagnosis data.)
Note5: Setting the OForced Camera Power ON� Mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: A, address: 10, set data: 01, and press the PAUSE
button.
The above procedure will enable the camera power to be turnedFig. 6-1-2.
on with the control switch block (SS11600) removed. After
completing adjustments, be sure to eOForced Camera Poxit the wer
ON Mode�.
Note6: Exiting the OForced Camera Power ON� Mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: A, address: 10, set data: 00, and press the PAUSE
button.
3) Select page: 0, address: 01, and set data: 00.
DCR-HC90/HC90E
6-5 |
ACEC
SONY
