6. Center Level Adjustment (PD-102 board)7. White Balance Adjustment (PD-102 board)
Set the VIDEO signal center level of the LCD panel to an appropriateCorrect the white balance.
value.If deviated, the LCD display color cannot be reproduced.
ModeCameraModeCamera
SubjectArbitrarySubjectArbitrary
Measuring Point1Pin of CN8201 (VG)Measurement Point
Check on LCD display
Measuring Instrument Digital voltmeterMeasuring Instrument
Adjusting PageDAdjustment PageD
Adjusting Address85Adjustment Address80, 81
Specified ValueA=6.50 ? 0.10 VdcSpecified ValueThe LCD display should not be
colored
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.Note:Check the white balance only when replacing the following parts. If
2) Select page: 3, address: 0C, set data: 20, and press the Pnecessary,A adjust them.USE
button of the adjustment remote commander.1. LCD panel
2. Light induction plate
3) Select page: 3, address: 22, set data: 08, and press the PAUSE
3. IC8001
button of the adjustment remote commander.
4) Select page: D, address: 85, change the data until the DC voltage
Adjusting method:
(A) of VG signal is set to the specified value.
1) Select page: 0, address: 01, and set data: 01.
5) Press the PAUSE button of the adjustment remote commander.2) Select page: 3, address: 0C, set data: 20, and press the PAUSE
6) Select page: 3, address: 22, set data: 00, and press the PAUSE
button of the adjustment remote commander.
button of the adjustment remote commander.
3) Select page: 3, address: 22, set data: 0B, and press the PAUSE
7) Select page: 3, address: 0C, set data: 00, and press the PAUSEbutton of the adjustment remote commander.
button of the adjustment remote commander.
4) Select page: D, address: 80 and 81, and set the data to the initial
8) Select page: 0, address: 01, and set data: 00.
value.
Note: To write in the non-volatile memory (EEPROM), press the
PAUSE button of the adjustment remote commander each time
to set the data.
AddressData
8090
818E
5) Check that the LCD display is not colored. If colored, change
the data of page: D, address: 80 and 81 so that the LCD display
is not colored.
Note: To write in the non-volatile memory (EEPROM), press the
PAUSE button of the adjustment remote commander each time
to set the data.
6) Select page: 3, address: 22, set data: 00, and press the PAUSE
button of the adjustment remote commander.
7) Select page: 3, address: 0C, set data: 00, and press the PAUSE
button of the adjustment remote commander.
8) Select page: 0, address: 01, and set data: 00.
5-24 |
ACEC
SONY
