DCR-TRV140/TRV140E/TRV140M
2. Flange Back Adjustment RadarWRadarWRadarWRadarWRadarWAdjusting method:
(Using the minipattern box)
Order Page Address DataProcedure
The inner focus lens flange back adjustment is carried out
automatically. In whichever case, the focus will be de1via0 ted dur01 -01
ing auto focusing/manual focusing.260113 Press PAUSE button.
360127 Press PAUSE button. (Note 4)
ModeCAMERA
Check the data changes to
Siemens star chart with ND filter f46or02
SubjectO01�.
minipattern box (Note 1)
Note 4:The adjustment data will be automatically input to page:
Measurement Point
Check operation on monitor TVF, address: 4E to 5D and 61.
Measuring Instrument
Adjustment PageFProcessing after Completing Adjustment:
Adjustment Address4E to 5D, 61
Order Page Address DataProcedure
Note 1:Dark Siemens star chart.
160100 Press PAUSE button.
Note 2:Check that the data of page: 6, address: 02 is O00�.
200100
If not, turn the power of unit OFF/ON.
Turn OFF the main power
3
Switch setting:supply.
1) NGHT SHOT ...................................................................Perform OFlange BackOFF
4
Check�.
Preparations before adjustments:
1) The minipattern box is installed as shown in the following fig-
ure.
Note 3:T he attachment lenses are not used.
2) Install the minipattern box so that the distance between it and
the front of lens of camcorder is less than 3 cm.
3) Make the height of minipattern box and the camera equal.
4) Check the output voltage of the regulated power supply is the
specified voltage ? 0.01 Vdc.
5) Check that the center of Siemens star chart meets the center of
shot image screen with the zoom lens at TELE end and WIDE
end respectively.
Specified voltage: The specified voltage varies according to the
minipattern box, so adjust the power supply
output voltage to the specified voltage written
on the sheet which is supplied with the
minipattern box.
Below 3 cm
Minipattern box
Camcorder
Camera
table
Regulated power supply
Output voltage : Specified voltage ?0.01 Vdc
Output current : more than 3.5 A
Red (+)
Black (�)
Yellow (SENS +)
White (SENS �)Need not connected
Black (GND)
Fig. 5-1-7
5-15 |
ACEC
SONY
