b) Setting electronicallyFilling with salt
(The dishwasher must be switched off)
Only use salt specifically designed for use in
The dishwasher is factory set at level 5. dishwashers.
All other types of salt not specifically designed for use in
1.Press the On/Off push button. The On/Off indicator light a dishwasher, especially table salt, will damage the water
illuminates.softener.
If other push button indicator lights are on, this means that Only fill with salt just before starting one of the complete
a wash programme has been selected. The programme washing programmes.
must be cancelled: press simultaneously the function push This will prevent any grains of salt or salty water, which
buttons 2 and 3 for about 2 seconds. All the indicator lights may have been spilt, remaining on the bottom of the
will turn off (except for the On/Off indicator light).machine for any period of time, which may cause
corrosion.
2.Press simultaneously function push buttons 2 and 3, until
the indicator lights of the function push buttons 1, 2 and 3
start flashing.To fill:
1.Open the door, remove the lower basket and unscrew the
3.Press the function push button 1, the indicator lights of
cap of the salt container by turning it anticlockwise.
function push buttons 2 and 3 turn off while the indicator
light of the push button 1 goes on flashing, at the same time 2.Pour 1 litre of water inside the container (this is necessary
the end of programme indicator light starts to flash.only before filling with salt for the first time).
The current level is indicated by the number of flashes of
3.Using the funnel provided,
the end of programme indicator light.
pour in the salt until the SALE
Example:5 flashes = level 5ZOUT
container is full.
SALT
SALZ
4.To change the level, press push button 1. Each time the 4.Replace the cap making SEL
push button is pressed the level changes. (For the selection sure that there is no trace
of the new level see the chart).of salt on the screw
thread or on the gasket.
Examples:
if the current level is 5, by pressing push button 1 once, 5.Screw on the cap tightly
level 6 is selected.turning it clockwise until it
if the current level is 10, by pressing push button 1 once, stops with a click.SR14
level 1 is selected.
5.To memorise the operation, switch off the dishwasher by
pressing the On/Off push button or wait about 60 seconds The salt container will require topping up periodically. You are
after which the dishwasher will automatically return to reminded of this by the salt indicator light on the control panel
setting mode.which comes on when the salt has finished.
The salt indicator light on the control panel can remain
illuminated for 2-6 hours after the salt has been
replenished, assuming the dishwasher remains switched
on. If you are using salts that take longer to dissolve then
this can take longer. The function of the machine is not
affected.
Do not worry if water over flows from the unit when filling with
salt, this is quite normal.
8 |
ACEC
ZANUSSI
