Water outlet hose connectionElectrical connection
The end of the drain hose can be connected in the followingThis appliance must be earthed.
ways: The manufacturer declines any responsibility should this
1.To the sink outlet spigot, securing it if necessary with a clip. safety measure not be observed.
If the plug that is fitted to your appliance is not suitable for the
2.Hooked over the edge of the sink using the special curved
socket, it must be cut off and the appropriate plug fitted.
plastic guide provided.
Important
3.To a stand pipe provided with vent-hole, minimum internal
The wires on the mains lead are coloured in accordance with
diameter 4 cm.
the following code:
123Green and Yellow - Earth
Blue- Neutral
21
O8
1min 4 cm
OBrown- Live
If you fit your own plug, the colours of the wires in the mains
lead of your appliance may not correspond with the markings
identifying the terminals in your plug.
Proceed as follows:
max 100 cm
min 30 cm max 100 cm
CS091.Connect the Green and Yellow (earth) wire to the terminal
in the plug which is marked with the letter "E" or the earth
The waste connection must be at a height of between 30 cm
symbol or coloured green and yellow.
(minimum) and 100 cm (maximum) from the bottom of the
2.Connect the Blue (neutral) wire to the terminal in the plug
dishwasher.
which is marked with the letter "N" or coloured black.
The drain hose can face either to the right or left of the
3.Connect the Brown (live) wire to the terminal in the plug
dishwasher
which is marked with the letter "L" or coloured red.
Ensure the hose is not bent or squashed as this could prevent
or slow down the discharge of water.
The sink plug must not be in place when the machine is
draining as this could cause the water to siphon back into the
machine. E
If you use a drain hose extension it must be no longer than 2
metres and its internal diameter must be no smaller than the13A
diameter of the hose provided.
L
N
O 18O 21
CE04
+ 2 m maxmax 100 cm
min 30 cm max 100 cmThe plug moulded onto the lead incorporates a 13amp BSI362
CS10
fuse. Only ASTA or BSI fuses should be used.
The plug must not be used if the fuse cover/carrier is lost. The
Likewise the internal diameter of the couplings used for
cover/carrier is indicated by the coloured insert at the base of
connections to the waste outlet must be no smaller than the
the plug.
diameter of the hose provided.
A replacement cover/carrier must be obtained from your local
Service Force Centre.
To isolate the dishwasher from mains, remove the mains plug.
Important!
The plug must still be accessible after the appliance has
been installed.
In case that the electrical cable has to be replaced, please
contact your local Service Force Centre.
17 |
ACEC
TRICITY BENDIX
