Models8.1 Pro8.2 Pro
Type2 WAY2 WAY
Usable frequency response50Hz-24kHz45Hz-24kHz
Peak SPL @ 1m, short term IEC noise source 106dB108dB
Sensitivity86dB86dB
Power Handling (Watts) 100 W100 W
Recommended amp power30-150W30-200W
Impedance nominal4&4&
Drive Units5"LF, 1" HF6.5" LF, 1" HF
System Magnetic ShieldingYesYes
Crossover frequency2.2K2.2K
Input connectors1 x phono speakon type /jack combo
Input connectors (active)1 x phono (unbalanced) 1 x XLR-1/4 jack combo balanced
Active ie slew rate, distortion10v/micro s10v/ micro s
FinishIRIDIUM color laminateIRIDIUM color laminate
Dimensions H x W x D (mm)295 x 198 x 252364 x 212 x 257
Dimensions of Active H x W x D (mm)295 x 198 x 280364 x 212 x 322
Weight (each kg)5.2kg6.2kg
Weight of active unit (each kg)7.5kg8.0kg
Active units only:
Usable frequency range50Hz-24kHz45Hz-24kHz
Drive units5" LF, 1" HF6.5" LF, 1" HF
Crossover frequency2.0K1.9K
Output SPL ((from peak power) 106dB108dB
IEC weighted noise @ 1m)
Bi-amplifier power (LF/HF)60W LF + 40W HF60W LF + 40W HF
Input sensitivity0.775V RMS (0 dBu)0.775V RMS (0 dBu)
Amplifier system distortion at0.1% @ 50W0.1% @ 50W
System Magnetic ShieldingYesYes
Signal to noise ratio100dB100dB
Mains voltage:
Voltage operating range at:
230V setting205-250V205-250V
115V setting100-130V100-130V
Power consumption:
Idle22W22W
Full output130W130W
Maintenance:
The high quality finish on your Diamond Pro is generally not in need of any care or
attention. Do not use abrasives or abrasive materials to clean the enclosure since the
finish may be marred. Never use water on or near electrical equipment.
The Diamond Pro-Active heat sink must be checked for clearance from obstructions,
lint fluff or anything that might cause overheating.
Safety:
Always use grounded A/C power. Take care to mount and operate your equipment in a
safe manner. Avoid exposure to rain and water.
Accessories:
Diamond Pro Series Subwoofer.
7 |