FZ20-PP.book 82 k 23767627F
Recording pictures (advanced)
+ Settings on the external flashWhen you are not using the external flash,
detach it or set it to Forced OFF.
[PRESET]
When attaching the external flash, the
-When setting to [PRESET] and
built-in flash cannot be activated.
attaching the external flash, the aperture
When attaching the external flash, the
value and the ISO sensitivity are
respectively set to [F2.8] and [ISO100] camera will become unstable.
on the camera regardless of the Detach the external flash when carrying
recording mode. Set the external flash to the camera.
[AUTO] and set the same value as the When attaching the external flash, do not
settings on the camera.hold only the external flash because it
-We recommend setting to [PRESET] for may detach from the camera.
normal use. When using the external flash and setting
[MANUAL]the white balance to [] (Flash), finely
-When setting to [MANUAL], you can set adjust the white balance. (P69)
the aperture value, the shutter speed If you take pictures close to the subject in
and the ISO sensitivity on the camera
Wide, a vignetting effect may appear on
even if the external flash is attached.the bottom of the recorded picture.
-When setting to [MANUAL], set to the
Read the operating instructions of the
Aperture-priority AE or the Manual
external flash for details.
exposure on the camera and then set
the same aperture value and the ISO
sensitivity on the external flash. (The
External Flash Burst Mode
external flash cannot control the light
[EX.FLASH BURST]
adequately due to the change in
aperture value on Shutter-priority AE
SCN1 SCN2
and Program AE.)
This mode allows you to take multiple
pictures at a time when the external flash is
Some commercial external flashes have
attached.
synchro terminals with high-voltage or
Set [EX.FLASH BURST] to [ON].
reversed polarity.
Press the Single/Burst Mode Button to
Using such external flashes may cause a
switch the burst mode setting.
malfunction or the camera may not
You can take up to 3 pictures by keeping
operate normally.
the shutter button pressed down.
Be sure to use Panasonic?s external flash
(DMW-FL28).+ Burst speed
If using other external flash units, please
Burst speedNumber of recordable
make sure the flash is designed for use
(pictures/pictures (pictures)
with a digital camera and the trigger
second)
voltage is based on ISO 10330 (less than
3
24 volts).
2
The available flash range is about max. 3
32.8 feet (10 m) in DMW-FL28. (When Approx. 2
setting to [ISO100])
When attaching the external flash, the
shutter speed becomes 1/60th to 1/250th Depending on the external flash you use
in normal mode, 1 to 1/250th in [NIGHT or the recording conditions, you cannot
PORTRAIT] in scene mode. (P58)take pictures in this mode or the amount
External flash mode is selected when of light may become insufficient for the
attaching the external flash to the camera second or subsequent pictures.
even if the external flash is turned off.
82 |
ACEC
PANASONIC
