DP-C354/C323/C264/C263/C213
DP-C322/C262
4. Perform the Service Modes F1-14 to F1-18 (Print Test Pattern 12 to 16).
5. Check the gap of the print pattern from the paper edge, refer to the Figure above.
6. Perform the Service Mode F6-045 to F6-049, to adjust the gap to 5.8 mm, for all the trays.
7. If the gap is less than 5.8 mm, input a (+) value. If more than 5.8 mm, input a (-) value.
8. Press "Reset" key first, and then press the ?Function?, and ?C? (Clear) keys simultaneously to exit
the Service Mode.
2.9.4.Color Registration
1. Insert paper into the 1st tray and change the tray setting to the appropriate paper size. Empty, or pull
all the remaining trays out (including the Sheet Bypass tray) to disable them.
2. Press the "Function", "Copy", and "3" keys simultaneously in that order to enter the Service Mode.
3. ?Input the password? to enter the Service Mode (default password is 00000000, except for C322/
C262 which do not require a password).
4. Perform the Service Mode F8-30.
5. Press "Reset" key first, and then press "Function" + "Clear" keys simultaneously to return to
standby.
2.10. Calibrating the LCD
1. Turn the Main Power Switch on the Back of the machine to the OFF (O) position, and leave the Power
Switch on the Left Side of the machine in the ON (I) position.
2. Ensure that the SD Memory Card with Firmware Update is not installed in the machine. If the Card is
installed in the machine, remove it.
3. Press and hold the ?Energy Saver ?, and ?Copy? keys down simultaneously, then turn the Main Power
Switch on the Back of the machine to the ON (I) position, and continue holding the keys for
approximately 30 seconds until the Display becomes stable.
The LCD Display starts blinking, and shows a ?+? on the upper left edge of the display.
Note:
If you do not hold the "Energy Saver", and "Copy" keys down long enough, the Display may go
OFF.
4. Press the ?+? on the upper left edge of the display, press the ?+? on the center, and press the ?+? on the
lower right edge of the display. Then the display goes to standby.
Caution:
Prevent any damage to the LCD Display by not pressing with Sharp Edged Objects such as a Ball
Point Pen, etc.
5. Reboot the machine by cycling the power. Turn the Main Power Switch on the Back of the machine to
the OFF (O) then back to the ON (I) position.
2.11. LEDs on the EC PCB
The LEDs are mounted on the EC PCB, which are working properly. The LEDs, and the signal names are
listed below.
LED 1 : +5V
LED 2 : +24VM (Voltage for Interlock and Motor drive)
LED 3 : +24VF (Voltage for Fan)
LED 5 : +5Vp (5V pilot)
Note:
1. LED 1 to 3 will be Off when machine is in Sleep mode.
2. The LED numbers are printed near the IPC PCB connector. (Order from left side)
75
Ver. 2.0SEPT 2006 |
ACEC
PANASONIC
