Adjustment
1. Loosen shafts of right and left by turning a screw driver 180 ° and 45 ° turns counter clockwise.
2. Enter the diagnostic program.
2-1. While pressing the SET button, put in the AC adaptor.
2-2.When the Power LED flashes in green, release the SET button, then press � button within 2 seconds.
3. Press + button twice, then press BACK button.
4. Insert a standard paper, and print pattern 4.
5. A part becoming light printed by a rectangle becomes a right angle.
6. If the part is round, loosen shafts of one (or both) that print is round by turning 45 ° turns counter
clockwise.
7. Repeat above 5 - 6 untill proper result is obtained.
8. Press BACK button, then press MENU button.
9. Insert a standard paper, and print pattern 3.
10. A result of print is even in a color.
(If there is a product, print pattern 3, and compare it)
If it is OK, go to 12.
If not, both sides becomes dim, loosen shafts of right and left by turning 45 ° turns counter clockwise.
One side becomes dim, loosen shaft of side that print becomes dim by turning 45 ° turns counter clockwise.
N 11 N |
ACEC
CASIO
