DPC-8.5
PANEL VIEWS-4
REAL PANEL
1 2345 678
L
R
9 10 11 12 13 14
1VIDEO OUTPUT 1 & 27RS232 port
These sockets output composite video and can beThis bidirectional RS-232 port can be connected to
connected to a composite video input on a TV oran external controller.
projector.
8AC INLET
2S VIDEO OUTPUT 1 & 2The supplied power cord should be connected here.
These sockets output S-Video and can be connected
to an S-Video input on a TV or projector.9OPTICAL DIGITAL AUDIO OUTPUT
This optical digital audio output can be connected to
3D.MIX AUDIO OUTPUTan optical digital audio input on a hi-fi amp, AV
These sockets output analog audio and can be connectedreceiver, or surround sound decoder (Dolby Digital, DTS).
to a stereo analog audio input on a TV, hi-fi
amp, or other component. If the source audio is10COAXIAL DIGITAL AUDIO OUTPUT
multichannel (Dolby Digital, DTS, DVD-Audio,
This coaxial digital audio output can be connected
to a coaxial digital audio input on a hi-fi amp, AVSACD), they output a 2-channel downmix.
receiver, or surround sound decoder (Dolby Digital, DTS).
4FRONT, SURR 1, CENTER & SUBWOOFER
AUDIO OUTPUT11IR IN/OUT
These sockets output 5.1-channel analog audio andThe IR IN socket can be used to connect a commercially
can be connected to a 5.1-channel analog audioavailable IR receiver, which can be used to
input on an AV receiver, surround sound decoderpickup signals from the remote controller when the
(Dolby Pro Logic), or other component. TheDPC-8.5 is located in another room, installed in a
FRONT outputs can be used as either front outputsrack, or is out of range of the remote controller
or downmix outputs.The IR OUT connector can be used to connect a
commercially available IR emitter, which can be
5SURR 2 AUDIO OUTPUTused to pass remote controller signals received by
the IR IN along to other components.
These sockets output the same analog audio as the
SURR1 outputs and can be connected to the analog
surround back left and right inputs on a 7.1-channel12 REMOTE CONTROL
AV receiver or other component. When using theseThese (Remote Interactive) connectors can be
sockets, the SURR MODE switch should be set toconnected to the connectors on your other Integra/
1+2.Onkyo AV components for interactive control.
To use you must make an analog audio connection
6SURR MODE (AUDIO OUT) switch(RCA) between the DPC-8.5 and your Integra/
Onkyo AV receiver, even if they are connected digitally.
This switch is used to set the surround output mode
of the analog multichannel audio outputs. If you
connect the SURR 2 outputs to a 7.1-channel AV13COMPONENT VIDEO OUTPUT 1
receiver or amp, set this switch to 1+2. This reducesThese sockets output component video and can be
the output level by 3 dB. If you're not using theconnected to a component video input on a TV or projector.
SURR 2 outputs, set it to 1.
14COMPONENT VIDEO OUTPUT 2
These sockets output component video and can be
connected to a component video input on a TV or projector. |
ACEC
ONKYO
