Front & Rear Panels
Front Panel
1POWER button 5Remote control sensor
This button is used to set the A-1VL to On or Off.This sensor receives control signals from the remote
controller.
2POWER indicator
This indicator lights up when the A-1VL is ON. 6Input selector control
While this indicator is illuminated, you can operate This control is used to select following input
the A-1VL with the remote controller.sources: CD, LINE 1, LINE 2, TUNER and
3MUTING indicatorPHONO.
This indicator lights up when the Muting function is 7DIRECT button
set.Turns on or off the DIRECT function. When you
use the A-1VL as a power ampliŢer, turn on the
4VOLUME controlDIRECT function.
This control is used to set the volume of the A-1VL.
Rear Panel
1PHONO 6SPEAKERS
These analog inputs can be used to connect aThese terminal posts are for connecting your speakers.
turntable with a moving-magnet cartridge.7Grounding screw
2TUNERThis screw is for connecting a turntableOs ground wire.
These inputs can be used to connect a tuner.8LINE 1
3CDThese inputs can be used to connect a TV or other
These inputs can be used to connect a CD player component with analog outputs.
with analog outputs.
9LINE 2 IN/OUT
4PREOUTThese analog inputs can be used to connect a
If you use the A-1VL as a preamp, these analog pre-cassette or MD recorder.
out can be connected to the inputs on a power amp.0SPEAKER IMPEDANCE SELECTOR
5MAIN INThis selector can be used to set the speaker imped-
If you use the A-1VL as a power amp, these analog ance values according to the speakers you use.
inputs can be connected to the outputs on a separateAAC INLET
preamp.
The supplied power cord should be connected here.
6 |
ACEC
