Installation
5. Inserting disc magazinesNOTES:
Any of the following methods may be used to insert discs?Insert with label facing upward.
into the changer:?Insert discs horizontally. Otherwise it may result in
1. Insert discs into a normal-type 50-disc magazine and thendamage to the discs.
insert the magazine into the changer.?Take care not to scratch or do other damage to the
2. Insert discs into a 20-disc hyper magazine and then insertrecording faces of discs.
the magazine into the changer.?Do not turn a disc magazine upside down while the
3. Use the control panel to specify the slot into which a disclock is disengaged. Otherwise it may result in discs
is to be inserted and transport a disc to the specified slotfalling out of the magazine.
from the mailslot.
4. Issue some commands from the host computer to open4 Insert magazine into changer.
the mailslot and transport a disc to the specified slot fromHolding the handle of the disc magazine, insert the disc
the mailslot.magazine into the changer following the changer guide
5. Issue some commands from the host computer to moverails until it runs against the stopper.
discs in the loaded hyper magazine to some slots withinAnd turn the handle to the left with pushing the magazine
the loaded 50-disc magazines.in so that the lock pin on the left of the magazine slides
into the corresponding hole along the side of the changer.
? Hyper magazine is not able to be inserted or removed when
the power to the changer is turned off.
? Methods 3 through 5 may be used after the changer isLock pin
ready for operation. When inserting discs in theseHole
methods, always be sure to insert empty disc magazines
first.Guide rails
Also note that methods 3 through 5 are used when
inserting locked-type 50-disc magazines. (See System
administrator mode: Mailslot submode on p. 32 for further
information.)
? Whether or not it is possible to use methods 4 and 5
depends on the function of changer control software being
used, and you should check the manual which comes with
the software to check if it supports these methods to insert
discs.
1. Insert discs into a normal-type 50-disc magazine and
insert the magazine into the changer.
1 Turn the release knob to the vertical direction to unlock.Â
2 Insert discs.
3 Turn the release knob to the horizontal direction to lock
the discs into place.
Handle
Shown above is the insertion to the front magazine bay.
Though the insertion to the rear magazine bay is almost
Release knobsame but note that the proper installation position is in the
place where it is very secluded.
To remove a disc magazine from the changer, pull the
Lock releaseLockhandle towards you and pull the magazine from the
changer.
Label
18
<DRC1105>
En |
ACEC
PIONEER
