%53@&OCPPL 1BHF 5VFTEBZ
"VHVTU
".
Advanced Setup�Continued
3-3. DTS
Audio Adjust Functions
These settings apply to DTS input signals.
Here you can set listening mode-related settings and
 a. LFE Levelfunctions.
With this setting you can set the level of the LFE (Low
Frequency Effects) channel for DTS sources to � , 1Press the [Receiver] button fol-
Receiver
lowed by the [Setup] button.
�10 dB, or 0 dB (default).
If you Ţnd that the low-frequency effects are too loud The main menu appears onscreen.
when playing DTS sources, set this to �10 dB or � dB.
3-4. D.F. 2ch
These settings apply to digital input signals, Dolby Dig-
ital and so on, with only 2 channels (2/0).
2Use the Up and Down [ ]/[ ]
 a. Input Channel (Mono)
buttons to select �4. Audio
This setting determines which channel is output when Enter
Adjust,� and then press [Enter].
the Mono listening mode is used with a stereo source.
The Audio Adjust menu appears.
L+R:Both the left and right channels are output
(default).
Left:Only the left channel is output.
Enter
Right:Only the right channel is output.
 b. Surround Mode
This setting determines the default surround mode for
digital input signals, Dolby Digital and so on, with only Use the Up and Down [ ]/[ ]
3
2 channels (2/0). This setting is unavailable if no center buttons to select menu items,
and surround speakers are connected.Enterand then press [Enter].
You can select PLII Movie (default), PLII Music, or PLII
Game.Menu
------------------------
Basic Setup
4.Audio Adjust
1.Initial Setup------------------------
3-5. Multiplex 2.Speaker Setup 1.Mono
Enter
2.PL Music
This setting applies to multiplex input signals.Advanced Setup 3.Enhance
3.Surround Setup 4.Orchestra
4.Audio Adjust 5.Unplugged
 a. Input Channel 5.Listening Mode Preset 6.Studio-Mix
6.Preference 7.TV Logic
This setting determines which channel is output from a
8.Mono Movie
stereo multiplex source. Use it to select audio channels 9.Theater-Dimensional
or languages with multiplex sources, multilanguage TV
broadcasts, and so on.
Use the Up and Down [ ]/[ ]
4
Main:The main channel is output (default).
buttons to select the settings,
Sub:The sub channel is output.Enterand use the Left and Right [ ]/
Main/Sub:Both the main and sub channels are output.
[] buttons to set them.
The settings are explained below.
3-6. Multichannel Input
These settings apply to the analog multichannel input.
 a. Subwoofer Sensitivity5When you�ve Ţnished, press the
When using the DVD analog multichannel input, the [Setup] button.
loudness of the connected subwoofer also depends on The setup menu closes.
the component that�s connected to that input. If you Ţnd
that it�s too loud, set this to 0 dB, +5 dB, +10 dB, or
+15 dB. The default setting is 0 dB.
Note:
� This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
57 |
ACEC
INTEGRA
