Other Settings for the Remote ControllerNContinued
Resetting the Remote ControllerRoll the scroll wheel to select
2
OSETUP,� and then press the scroll
You can reset the remote controller to its default set-wheel.
tings.
1Press and hold the [Custom] but-
ton for more than three seconds.
Custom
The remote controller enters Custom
mode.
Roll the scroll wheel to select OIR/
3
2Roll the scroll wheel to select RF,� and then press the scroll
OSETUP,� and then press the scroll wheel.
wheel.
4Roll the scroll wheel to select OIR�
3Roll the scroll wheel to select or ORF,� and then press the scroll
ORESET,� and then press the scroll wheel.
wheel.When you select OIR.�
Roll the scroll wheel to select 5If you select ORF,� roll the scroll
4wheel to select the same ID as the
OYES,� and then press the scroll
wheel.RF receiver, and then press the
scroll wheel.
The remote controller is reset to its
IDs 0 to 9 and A to F can be selected.Using the Remote Controller
default settings.
Roll the scroll wheel to select the
6
Using the Remote Controller with same channel as the RF receiver,
and then press the scroll wheel.
Radio Frequency
Channels 0 to 3 can be selected.
You can set the remote controllerOs transmission signal If the ID and channel have been set suc-
format to either infrared (IR) or radio frequency (RF). cessfully, OOK� appears on the display.
The default setting is IR.
This is useful when, for example, the DTR-10.5 is
installed in a rack or is not in line of sight of the remote
controller as it allows you to use a commercially avail-
able RF receiver to pick up commands from the remote
controller, which are then fed to the DTR-10.5 via its IR
IN socket. For this to work, you must assign the same
ID and channel to the remote controller and RF receiver.
1Press and hold the [Custom] but-
ton for more than three seconds.
Custom
The remote controller enters Custom
mode.
141 |
ACEC
