Using the remote controller
Controlling an Onkyo/Integra MD recorder
Note:
Make sure that you point the transmission part on the remote con-
troller toward the sensor area on the MD recorder.
1. Press the MODE MD/AUX button.
2. Press the desired MD operation button.
Turning the power on and off to the MD recorder
MODE MD
POWER ON/STNBY
: Turning on or standby the power to the MD
recorder
: Down
:Up
: Playback
: Stop
: Rewind
MD
: Fast forward
operation
buttonsREC o: Record
: Pause
EJECT r: Eject
1~9, +10 : Numeric keys
ENT: Confirm
Numeric keys,
ENT buttonYou may also use the following buttons:
VOL D/N: Adjusting the volume level of the receiver
MUTING: Muting the sound from the receiver
Controlling an Onkyo/Integra tape deck
MODE Note:
AUDIO/TAPEFirst connect an Onkyo/Integra tape deck using the zconnection.
(See page 7.)
1. Press the MODE AUDIO/TAPE button.
2. Press the desired tape deck operation button.
: Playback
: Stop
: Rewind
: Fast forward
TAPE
operationREC o: Recording/pause
buttons
: Reverse playback
You may also use the following buttons:
VOL D/N: Adjusting the volume level of the receiver
MUTING: Muting the sound from the receiver
MODE SAT, CABLE, VCR, and TV buttons
No preset codes are programmed into the MODE SAT, CABLE,
MODE SAT,
VCR, and TV buttons. You can use these buttons to program remote
CABLE,VCR,
TVcontroller signals of other devices. (See page 52.)
You may use the following buttons:
VOL D/N: Adjusting the volume level of the receiver
MUTING: Muting the sound from the receiver
51 |