POWER CLEAN* Washing System
Your dishwasher cleans by spraying a mixture of hot, clean water and detergent
against soiled surfaces of dishes. When a cycle is started,the dishwasher fills with water
to about the level of the heating element. This water is pumped through the rotating
spray arms, through the POWER CLEAN Module which removes food particles, and back
through the rotating spray arms. Soiled water is pumped out and replaced with clean
water during a cycle - the number of times depends on the cycle being used.
The POWER CLEAN* Module removes food
particles from the water, stores them, then
washes them down the drain.
Load dishes so soiled surfaces face pow-
erful spray from rotating arms.
Step-sstig preparation for washing
It Is not necessary tains a chopping device which will reduce the
to rinse dishes before size of food items.
putting them Into the If hard items such as fruit seeds, nuts and egg
dishwasher. Just re- shells enterthe POWER CLEAN? Module, you might
move large pieces, hear chopping, grinding, crunching or buzzing
bones, and other hard sounds. Those sounds are normal when hard
items. The POWER items enter the module. DO NOT LET METALLIC
CLEAN* Module will ITEMS (I.E. POT HANDLE SCREWS) GET INTO THE
remove food Darticles POWER CLEAN? MODULE. THIS COULD RESULT IN
from the water. It con- DAMAGE TO THE POWER CLEAN* MODULE.
~~
Hot water is a must
Hot water dissolves turn on hot water faucet nearest the dish-
and activates the washer. Let water run until it is as hot as pos-
dishwashing deter- sible, then check with a candy or meat
h gent. Hot water dis- thermometer. If the temperature is too low,
solves grease on have a qualified person raise the water
dishes and helps dry heater thermostat setting.
z glasses spot-free. 2 Use HI-TEMP WASHING Option. If water heat-
Make certain loads ing is needed, a thermostat will delay the
. are washed in hot cycle until temperature reaches 145°F
h
water fat IeastlPOF - (63?C). If water is hot enough, the cycle will
??I
60°C): Two ways to proceed with no delay. This lets you turn
Check Water have a reliable hot down your water heater, if you choose,
Temperature
water supply... without cutting back on hot water needed
1. Maintain 140°F water supply at central for good dishwashing.
water heater. To check water temperature,
4 |
ACEC
WHIRLPOOL
