To adjust the top rack
Loading Top Rack1. Hold the top rack with one hand near the adjuster.
The top rack is designed for cups, glasses, and smaller items.
(See recommended loading patterns shown.)
NOTE: The features on your dishwasher rack may vary from the
drawings shown.
2. With the other hand, pull out the top of the adjuster.
3. Raise or lower the rack to one of the preset positions.
4. Release the adjuster.
Repeat the steps for the remaining adjusters as needed. The 4
adjusters can be raised or lowered separately or together. The
top rack does not have to be level.
Cup and glass loadLight item clips (on some models)
The light-item clips hold lightweight plastic items such as cups,
lids, or bowls in place during washing. You can move a clip
anywhere in the rack.
To move a clip
1. Pull the clip up and off the tine.
2. Reposition the clip on another tine.
Mixed load
Place items so open ends face down for cleaning and
Loading Bottom Rack
draining.The bottom rack is designed for plates, pans, casseroles, and
Load glasses in top rack only. The bottom rack is not utensils. Items with cooked-on or dried-on food should be loaded
designed for glasses. Damage can occur.with soiled surfaces facing inward to the spray. (See
recommended loading patterns shown.)
Place cups and glasses in the rows between tines. Placing
them over the tines can lead to breakage.NOTE: The features on your dishwasher rack may vary from the
drawings shown.
China, crystal, and other delicate items must not touch each
other during dishwasher operation. Damage may occur.
Load plastic items in the top rack only. Only plastic items
marked ?dishwasher safe? are recommended.
Load plastic items so the force of the spray does not move
them during the cycle.
To avoid chipping, do not let stemware touch other items.
Small bowls, pans, and other utensils can be placed in the
top rack. Load bowls in the center section for best stability.
Adjustable 3-position top rack
(on some models)Mixed load
You can raise or lower the top rack to fit tall items in either the top Do not load glasses, cups, or plastic items in the bottom
rack. Load small items in the bottom rack only if they are
or bottom rack. Two adjusters are located on each side of the top secured in place.
rack. Each adjuster has 3 preset positions. The high and low
positions are marked on the adjuster.Load plates, soup bowls, etc., between tines and facing
inward to the spray.
Overlap the edges of plates for large loads.
10 |
ACEC
WHIRLPOOL
