SANI RINSE? Option
Select this option to raise the water temperature in the final rinse Cycle Status Indicators
to approximately 155°F (68°C) for 10 minutes. The SANI RINSE
option adds heat and time to the cycle. In the Pots & Pans and Follow the progress of your dishwasher with the Cycle Status
Heavy Wash cycles, this high-temperature rinse sanitizes your Indicators.
dishes and glassware in accordance with the NSF Protocol P153
Sanitization and Cleaning Performance of Household Spray-Type
Dishwashers.
NOTE: Your model may have some or all of these indicators.
Sensing
Your dishwasher senses the soil level on the dishes. Soil level
NOTE: Use the SANI RINSE option with the Pots & Pans and determines the length of some cycles, the amount of heat added
Heavy Wash cycles.to the wash or rinse, and the cycle needed for the load. Sensing
glows during the soil sensing parts of the cycle. Wash action
Air Drycontinues while sensing occurs.
Select this option to dry dishes without heat and save energy.
The dishes take longer to dry and some spotting can occur.Heat Water
Heat Water glows whenever water is heated during a cycle. Wash
or rinse action continues as the water heats.
Clean
Clean glows when a cycle is finished. The light turns off when you
open the door or press Cancel/Drain.
For best drying, use a liquid rinse aid. Some items (such as Sanitized
plastics) may need towel drying.If you select the SANI RINSE? option, Sanitized glows when the
NOTE: The dishwasher automatically heats the air in the SANI RINSE cycle is finished. If your dishwasher did not properly
dishwasher during the ?dry? portion of the cycle unless you sanitize your dishes, the light flashes at the end of the cycle. This
select Air Dry.can happen if the cycle is interrupted. The light goes off when
you open the door.
Delay Hours
Use Delay Hours to run your dishwasher at a later time or during Locked
off-peak hours. You can add items to the load anytime during the Use Locked to prevent unintended use of the dishwasher. You
delay countdown. After adding items, close the door firmly until it can also use the Locked feature to prevent unintended cycle or
option changes during a cycle.
latches. The delay countdown will not continue if the door is not
latched.NOTE: When Locked is lit, all buttons are disabled.
To delay the startTo lock the controls
Press and hold
1. Close the door.
2. Press Delay Hours 1 time for a 2-hour delay, 2 times for a 4-
hour delay, or 3 times for a 6-hour delay.
for 5 seconds. Locked glows. If you press any pad while your
dishwasher is locked, the light flashes 3 times.
To unlock the controls
3. Select a wash cycle and option.Press and hold Air Dry for 5 seconds until the light turns off.
NOTE: The dishwasher door can be opened while the controls
The number glows above Delay Hours. The dishwasher starts the
cycle in the selected number of hours. If you do not press a cycle are locked.
within 30 seconds, the Delay Hours indicator turns off.
NOTES:
To cancel the delay and cycle, press Cancel/Drain.
To cancel the delay and start the cycle, press Delay Hours
until ?6? glows. Then press Delay Hours one more time. The
delayed cycle starts.
13 |
ACEC
WHIRLPOOL
