%741&@&OCPPL 1BHF 8FEOFTEBZ
"VHVTU
1.
Troubleshooting�Continued
 HDMI Status Mode
If you�re using an HDMI connection and there�s no picture or sound, you can check the status of the HDMI connection
by pressing and holding down the DVD player�s [DISPLAY] button for 10 seconds until a message ID appears on the
display. Look up the message ID in the following tables and check the HDMI connections and settings on both the DVD
player and the connected component.
HDMI connection and HDMI-related settings status
Displayed IDMessage
Turn the DVD player and the connected component off, then turn them on again. Make sure that
MSG ID 001
the connected component is working properly and that the DVD player�s HDMI settings are conŢg-
MSG ID 015
ured suitably for that component.
No picture from the HDMI connection
Displayed IDMessage
MSG ID 002The HDMI Output Setting is set to Off. Change it to On (page 43).
MSG ID 003The HDMI cable may not be connected properly. Check the connection. Also, make sure the HDMI
MSG ID 004input on the TV or AV receiver is correctly conŢgured to received HDMI.
Make sure the HDMI input on the TV or AV receiver is correctly conŢgured to received HDMI.
The connected component may not support HDCP. Make sure the connected component supports
MSG ID 005
HDCP.
MSG ID 006
Turn the DVD player and the connected component off, then turn them on again.
MSG ID 007
The DVD player may be connected to the other component�s DVI jack. Some TVs may not properly
receive the video output by the DVD player. Also, with a DVI connection, there will be no sound.
The DVD player�s HD Resolution setting is set to 720p or 1080i. If your TV doesn�t support these
MSG ID 008
resolutions, select another resolution (page 43).
The connected component may not be receiving the HDMI signal properly.
MSG ID 009
Try selecting another resolution on the DVD player (page 43).
No sound from the HDMI connection
Displayed IDMessage
The DVD player�s Digital/HDMI Audio Out setting is set to Off. Change the setting to All or PCM
MSG ID 010
(page 48).
MSG ID 011The connected component may not support 96 kHz PCM. Set the DVD player�s Linear PCM Out
MSG ID 014setting to Down Sample On (page 48).
MSG ID 012The connected component may not support Dolby Digital. Set the DVD player�s Digital/HDMI Audio
MSG ID 013Out setting to PCM (page 48).
MSG ID 016The connected component may not support DTS. Set the DVD player�s Digital/HDMI Audio Out
MSG ID 017setting to PCM (page 48).
MSG ID 020Audio from SACDs is not output by the HDMI OUT (page 19).
61 |
ACEC
ONKYO
