SONY DVA-A1100 Repair Manual

2-2. DVA-P1100
9. Insert the sub picture tool tape into the VTR and locate16. Select the desired event from the event list of the
the segment of the tape having the time code of aroundCheck window and click the [Display] button.
01 : 09 : 50 : 00.
10. Click the [Encode] button on the OEncode Setup�
dialog box and start the encoding.
11. The Encode window appears.
12. Press the [PLAY] button on the VTR.
Check the following :
. The TC value that is displayed in the TC text box of
the Encode window is displayed and agrees with the
TC value that is displayed on the TC reader (BVG-
1500) and the VTR.
. The bar graph in the center of the Encode window
extends to the right as the encoding progresses.Check the following :
. The encoded sub title characters appear on the. The encoded sub title characters appear on the
display as they are, mixed with the output of thedisplay as they are, mixed with the output of the
signal generator (TSG-422).signal generator (TSG-422).
13. The encoding finishes in about three minutes and17. Click the [Close] button to close the Check window.
ODone� appears. Click the [OK].18. Click the [Exit] button of the OSub Picture Encoding�
14. Click the [Close] button to close the OEncode Setup�window to end the checking.
dialog box.n
15. Click the [Check/ReEncode] of the OSub PictureDo not click the [Done] button.
Encoding� window.If ODone� is clicked by mistake, copy the project data
of the tool software CD into the S drive again.
Done button
2-10 (E)DVA-A1100/P1100/R1100