STANDARD CONNECTIONSGETTING STARTED
CONNECTING THE POWER SUPPLYOPERATION
NOTE
1 Plug the female end of the power cable supplied into the
Power connector on the rear of the player.- Unless otherwise mentioned, all operations can be carried
out with the remote control. Always point the remote con-
2 Plug the male end of the cord into an AC outlet.trol directly at the player, making sure there are no obstruc-
tions in the path of the infrared beam.
- When the player is in the OOFF� position, it is still consu-
ming some power. If you wish to disconnect your player- When there are corresponding keys on the front panel, they
completely from the mains, withdraw the plug from the ACcan also be used.
Outlet.
CautionSWITCHING ON
1 Switch on the TV and select the video input for your DVD-
Only qualified service personnel should remove the
cover or attempt to service this device.Video player.
2 To enjoy sound through your stereo system, turn on the
system and select the source input for the DVD-VideoINFRA RED REMOTE CONTROL
player.
LOADING THE BATTERIESOR
1 Open the battery compartment cover.To enjoy DVD-Video with multichannel (surround) sound,
switch on the Home Cinema system and select the source
2 Insert two 'AAA' (R03) batteries as indicated inside theinput for your DVD-Video player.
battery compartment.
3 On the front of the DVD-Video player, press Power
3 Close the cover.ON/OFF. The player display lights, and the OSD invites
you to load a disc.
Caution
4 With Autoplay ON (the factory setting) any disc already
Do not mix old and new batteries. AND never mix diffe-
rent types of batteries (standard, alkaline and so on).loaded in the player starts to play.
inse
NTSC/PAL SETTING
You can switch the NTSC/PAL setting of the DVD player to
match the video signal of your TV. This setting only affects
the televisionOs on-screen display that shows the stop and
setup modes. You may select either NTSC or PAL. To change
the DVD player setting to PAL or NTSC, follow the step below.
1 Press POWER ON/OFF button on the front panel of the
DVD player to turn OFF the DVD player.
2 Press and hold / and P on the front of the DVD player.
While holding / and P, press POWER ON/OFF to turn
ON the DVD player.
3 After PAL or NTSC appears on the display panel of the
DVD player, release / and P at the same time. The PAL
or NTSC that appears on the display panel indicates the
current setting.
4 To change the setting, press P within 3 seconds. The
new setting (PAL or NTSC) will appear on the display
panel.
ee nn gg ll ii ss hh 13 |
ACEC
PHILIPS
