DV-K821DZ-RG/J(GB) 00.11.10 4:39 PM A� 19
uIf you are using a RCA cable, select the AV
input on the TV to see the picture from theCONNECTIONS
video.
uIf you are not using a RCA cable,select the
button number on the TV reserved for videoa n d c o p y i n g
input to see the picture from the video.
To the TV via antenna cable (if you are not using a RCA cable)
If you are not using a RCA cable, your video can transmit pictures and sound to the TV via the
coax aerial cable. Just tune the TV to the video's transmitting channel (factory set to UHF CH
52). Tune the TV carefully to ensure the best pictures and sound.
Once you have carried out the steps in
"Connecting up the video cassette recorder"
(page 4), switch on your TV.
OKPress the OK button of the videoOs remote control
5 sec.longer than 5 seconds to call the video?s test
picture.
Tune the TV to the test picture using the channel
pre-set functions of your TV as described in its
manual.
When you have found the test picture, store it
under the button number on your TV for video
input.
Press the OK button of the videoOs remote control
MENU
again longer than 5 seconds to release the test
picture.
PR �
2x
OK
PR �
2x
If the quality of the test picture transmitted to the TV is poor due to interference caused by
OK
a station transmitting on channel 52, you can tune the video to a different transmitting
channel. Find a free channel between 21 and 69 on your TV.
RF OUTPUT SET
Call the videoOs "MAIN MENU" choose
PR52
"VCR Setup" then "RF Output Set".
SYSTEMBG DK
OK
0-9:select (21-69)
/:select (BG/DK)Type in the free channel.
OK:confirm MENU:end
MENU
Store and exit.
uIf the quality of the test picture transmitted to the TV is poor, fine-tuning on the TV may
help (refer to the TV manual).
u Without a RCA cable, you will not get stereo sound from a TV capable of stereo sound.
19 |
ACEC
DAEWOO
