H9821MD_DFU_EN1_0214 2/14/05 11:14 AM Page 22
English22 Videotape Recording
Read and follow the steps below to record a television program
Turn on the TV.
onto a videotape.
1
IBefore you begin,make sure the DVD/VCR is in VCR mode.
Insert a tape in the
Press VCR so VCR light appears on the front of the DVD/VCR.
DVD/VCR.
2
Turn on the TV and set it to channel 3 or 4 or the
Video In channel. If you connected the DVD/VCR to the
1STANDBY-ON
TV using the supplied audio and video cables, select your
TVOs Video In channel. Details are on page 10.SEARCH MODEDISPLAY
If you connected the DVD/VCR to the TV using the
REPEAT REPEATAUDIO
supplied RF coaxial cable, choose channel 3 (or 4) at the TV.
A-B
Details are on pages 7-9.SUBTITLE ZOOMANGLESKIP / CH
4
RETURNTITLECLEAR/RESET SLOW
Insert a tape with its record tab intact into the
cassette compartment of the DVD/VCR. If tape
2
playback begins, press STOP C.VCRVCR/TVDVD
DISC/VCRSYSTEM
MENUMENU
Press SPEED until the desired tape speed (SP or
SLP) appears briefly on the screen. Details about tape
3OK
speed are on page 58.
Press SKIP /CH KK or SKIP ww/CH LL or theSTOPPLAYPAUSE
Number buttons to select the TV channel to
4TIMER SETMARKERRECORD6
record.7
SPEED
Press RECORD I to start recording. OREC� will123
appear on the DVD/VCROs display panel.45673
5
To pause the recording, press PAUSE k once. OREC�890+10
4
will flash. To resume recording, press RECORD I or
6
press PAUSE k again. OREC� will reappear.
5-6
To stop recording, press STOP C.
7
Helpful Hints
Y Other recording options are on
pages 23-28.
Y The VCR will record in a preset
Recording Prevention
volume.
Video cassettes have record tabs to ensure that recordings are
Y Pause will switch to Stop after
not accidentally erased.
5 minutes to protect the VCR
and the tape from damage.
To prevent recording, break off the tab with a
When a recording is paused,
screwdriver.
1review the pause time remaining
with the  marks on the
To allow recording, cover the hole with clear tape.
screen. Each  mark equals
21 minute remaining. During the
last minute of paused recording,
the  mark will flash.
Remove theCover theY If any menu is on the TV screen,
tab to preventhole to allowRECORD I on the remote
recording.recording.does not function. Press
CLEAR/RESET to remove the
menu.Then, press RECORD I.
Or, use RECORDI on the
front of the DVD/VCR. |
ACEC
PHILIPS
