DVP-F5/FX1
SECTION 6
TEST MODE
6-1. GENERAL DESCRIPTION
### Syscon Diagnosis ###
The Test Mode allows you to make diagnosis and adjustment easilyDiag All Check
using the remote commander and monitor TV. The instructions,
diagnostic results, etc. are given on the on-screen display (OSD).No. 2 Version
6-2. STARTING TEST MODE2-3. ROM Check Sum
Check Sum = xxxx
Press TITLE , CLEAR , POWER buttons on the remote
commander in this order with the power of main unit in OFF status,Press NEXT Key to Continue
and the Test Mode starts, then the menu shown below will be
displayed on the TV screen. At the bottom of menu screen, thePress PREV Key to Repeat
-
model name and revision number are displayed.
To execute each function, select the desired menu and press itsFor the ROM Check, the check sum calculated by the Syscon is
number on the remote commander.output, and therefore you must compare it with the specified value
To exit from the Test Mode, press the POWER button.for confirmation.
Test Mode MenuFollowing the message, press NEXT key to go to the next item,
or PREV key to repeat the same check again. To quit the diagnosis
and return to the Check Menu screen, press STOP or ENTER
0. Syscon Diagnosiskey. If an error occured, the diagnosis is suspended and the error
1. Drive Auto Adjustmentcode is displayed as shown below.
2. Drive Manual Operation
3. EVR Adjust### Syscon Diagnosis ###
4. Emergency History
5. Version Information
6. Video Level Adjustment
Exit : Power Key 3-2. EEPROM Check
Error 03 : EEPROM Write/Reed N
Model : DPX13xxxxAddress : 00000001
Revision : 1.xxxx
Write Data : 2492
Read Data : 2490
Press NEXT Key to Continue
6-3. SYSCON DIAGNOSISPress PREV Key to Repeat
-
The same contents are board detail check by serial interface can be
checked from the remote commander.Press STOP key to quit the diagnosis, or PREV key to repeat the
On the Test Mode Menu screen, press 0 key on the remotesame item where an error occurred, or NEXT key to continue the
commander, and the following check menu will be displayed.check from the item next to faulty item.
### Syscon Diagnosis ###Submenu
Check Menu
0. QuitSelecting 2 and subsequent items calls the submenu screen of each
1. Allitem.
2. VersionFor example, if O5. Supply� is selected, the following submenu will
3. Peripheralbe displayed.
4. Servo
5. Supply### Syscon Diagnosis ###
6. AV DecoderCheck Menu
7. VideoNo.5 Supply
8. Audio0. Quit
-1. All
2. ARP Register Check
3. ARP to RAM Data Bus
4. ARP to RAM Address Bus
0. Quit5. ARP RAM Check
Quit the Syscon Diagnosis and return to the Test Mode Menu.-
1. All
All items continuous check
This menu checks all diagnostic items continuously. Normally, all
items are checked successively one after another automatically
unless an error is found, but at a certain item that requires judgment0. Quit
through a visual check to the result, the following screen is displayedQuit the submenu and return to the main menu.
for the key entry.
6-1 |
ACEC
SONY
