PIONEER DVPT100S Repair Manual

1234
7.5 DISASSEMBLY
1. REMOVAL OF MECHANICAL PARTS AND P.C. BOARDS
A1-1: TOP CABINET, FRONT CABINET AND1-3: DVD DECK/DVD PCB ASSY
OPERATION PCB ASSY (Refer to Fig. 1-1) (Refer to Fig. 1-3)
1. Remove the 5 screws 1.1. Make the short circuit on the position as shown Fig. 1-3
2. Remove the Top Cabinet in the direction of arrow (A).using a soldering. If you remove the DVD Deck with no
3. Disconnect the following connector: (CP651).soldering, the Laser may be damaged.
4. Unlock the 8 supports 2.2. Unlock the support 1 and remove the Deck Top Holder
5. Remove the Front Cabinet in the direction of arrow (B).in the direction of arrow (A).
6. Remove the 2 screws 3.3. Remove the 2 screws 2.
7. Remove the OPERATION PCB Assy in the direction of 4. Remove the 2 screws 3.
arrow (C).5. Disconnect the following connectors:
(CP501, CP8001).
6. Remove the DVD Deck in the direction of arrow (B).
B1
Top Cabinet7. Remove the 2 screws 4.
18. Remove the DVD PCB Assy in the direction of arrow
1(C).
9. Remove the 3 screws 5.
1
10. Remove the Front Angle in the direction of arrow (D).
(A)
14
Front Cabinet
4
DVD PCB Asy
(B)
2DVD Deck
233Pickup PCB
C
23Deck Top Holder
22(C)
2
(C)
2OPERATION PCB Assy1
3
2
2(A)
Fig. 1-12
(B)
Make the short circuit
using a soldering.
1-2: FLAP (Refer to Fig. 1-2)
5
1. Open Flap to 90° and flex in direction of arrow (A), at
5
the same time slide in direction of arrow (B).
D
2. Then lift in direction of arrow (C).(D)
5
Front Angle
(A)
Fig. 1-3
(C)
NOTE:
When the installation of the DVD Deck, remove all the
(B)soldering on the short circuit position after the connection of
EPick Up PCB and VCR PCB connector.
Flap
Fig. 1-2
F
90DV-PT100-S
1234