SAFETY PRECAUTIONS
SUBJECT : IMPLOSION4. Wall and shelf mounted installations using a commercial mounting
kit, must follow the factory approved mounting instructions. A
1. All direct viewed picture tubes are equipped with an integral implo-receiver mounted to a shelf or platform must retain its original
sion protection system, but care should be taken to avoid damagefeet(or the equivalent thickness in spacers) to provide adequate
during installation. Avoid scratching the tube. If scratched, replaceare flow across the bottom, bolts or screws used for fasteners
it.must not touch and parts or wiring. Perform leakage test on cus-
2. Use only recommended factory replacement tubes.tomized installations.
5. Caution customers against the mounting of a receiver on sloping
SUBJECT : TIPS ON PROPER INSTALLATIONshelf or a tilted position, unless the receiver is properly secured.
6. A receiver on a roll-about cart should be stable on its mounting to
1. Never install any receiver in closed-in recess, cubbyhole or closelythe cart. Caution the customer on the hazards of trying to roll a cart
fitting shelf space over, or close to heat duct, or in the path ofwith small casters across thresholds or deep pile carpets.
heated air flow.7. Caution customers against the use of a cart or stand which has not
2. Avoid conditions of high humidity such as : Outdoor patio installa-been listed by underwriters laboratories, inc. For use with their
tions where dew is a factor. Near steam radiators where steamspecific model of television receiver or generically approved for
leakage is a factor, etc.use with T.V.?s of the same or larger screen size.
3. Avoid placement where draperies may obstruct rear venting. The
customer should also avoid the use of decorative scarves or other
coverings which might obstruct ventilation.
4 |