Installation instructions
Any electrical and/or plumbing work required to installThe dishwasher features fill and drain hoses which can be
this appliance should be carried out by a qualifiedturned either to the left or the right to suit the installation by
electrician and/or plumber or competent person.means of the locknut. (Attention! NOTall models of
Remove all packaging before positioning the machine.dishwashers have fill and drain hoses provided with locknut. In
this case, this kind of facility is not possible).
If possible, position the machine next to a water tap and aThe locknut must be correctly fitted to avoid water leaks.
drain.
If the machine is connected to new pipes or pipes which have
not been used for a long time, you should run the water for a
few minutes before connecting the inlet hose.
Fitting under a counter Do not use, for connection, old hoses which have been
(kitchen worktop or sink)used in another appliance.
By removing the machines worktop, you can install it under aThe dishwasher is fitted with safety devices that prevent the
close fitting sink unit or a pre-existing top, providing thewash water returning into the drinking water system and
comply with the applicable plumbing regulations.
dimensions of the recess correspond to those shown in the
picture.
570 - 600Water inlet hose with safety valve
After connecting the double-walled water inlet hose, the safety
valve is next to the tap. Therefore the water inlet hose is only
under pressure while the water is running. If the water inlet820
hose starts to leak during this operation, the safety valve cuts600
off the running water.
Please take care when installing the water inlet hose:
IN05
- The distance between the bottom edge of the safety value
and the floor on which the dishwasher is standing must be at
Proceed as follows:least 30 cm:
Remove the machines worktop by unscrewing the two rear
retaining screws, pull from the front and slide out the rear- The electrical cable for the safety valve is in the double-
slots, lifting the worktop.walled water inlet hose. Do not immerse the water inlet hose
or the safety valve in water.
Insert the machine after adjusting height and levelling with the
adjustable feet. When inserting the machine, ensure that the- If water inlet hose or the safety valve is damaged, remove
the mains plug immediately.
water inlet and drain hoses are not kinked or squashed.
- A water inlet hose with safety valve must only be replaced by
If the dishwasher is later used as a free-standing appliance,a specialist or by the consumer services department.
the original worktop must be re-mounted.
The plinth on free-standing appliances is not adjustable.- Place the water inlet hose in such a way that it is never
higher than the bottom edge of the safety valve.
Levelling
Good levelling is essential for correct closure and sealing of
the door.
When the appliance is correctly levelled, the door will not catch
on either side of the cabinet.
If the door does not close correctly, loosen or tighten the
adjustable feet until the machine is perfectly level.
Water supply connections
This dishwasher may be fed with either hot (max. 50°C) or cold
water. Nevertheless we advise you a cold water supply.CS19
A hot water supply is not always efficient with very soiled
crockery as it shortens the washing programmes a lot.
For making the connection itself, the coupling nut fitted to the
machines supply hose is designed to screw onto either a 3/4"
inch gas thread spout or to a purpose made quick-coupling tap
such as the Press-block.
The water pressure must be within the limits given in the
technical specifications. Your local Water Authority will advise
you on the average mains pressure in your area.
The water inlet hose must not be kinked, crushed, or entangled
when it is being connected up.
4 |
ACEC
OTHERS
