Operating sequence
1. Check the filters 8. Start the programme
Ensure they are clean and properly positioned Depress the On/Off pushbutton.
(see "Maintenance and cleaning").The On/Off indicator light will come on and
the machine will start.
If you wish to interrupt the washing
2. Check that there is rinse aid programme at any time press this button
again.
and salt
9. At the end of the washing
3. Load the dishes
programme
Remove any scraps of food.
Pull the lower basket out and arrange the At the end of the programme the
dishwasher will automatically stop.
saucepans, plates and cutlery in it.
The On/Off indicator light remains on until
Pull the upper basket out and arrange the the On/Off pushbutton is depressed.
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
10. Switch off the dishwasher
Switch off the dishwasher by pressing the
4. Ensure that the spray arms can
On/Off pushbutton and open the door.
rotate freely.
5. Measure out detergent
When the washing programme has
Add the required amount of detergent into the finished, it is recommended that the
dispenser according to the "Washing
dishwasher is unplugged and the water
programmes" chart.tap turned off.
Close the detergent dispenser lid.
In general it is not advisable to open the
door while the machine is working;if the
6. Close the dishwasher doordoor is opened however, a safety device
ensures that the machine stops.
7. Set the programme
Push the programme selector dial to make it Important!
pop out.Care must be taken if the door is opened
Then turn the programme selector dial
during the hot phase or immediately
clockwise until the letter of the programme yafter a prou ogramme has finished, as
wish to select corresponds with the programme steam may escape.
marker on the control panel.
Select the temperature according to the
instructions in the "Washing programmes" chart
(see "Required pushbuttons").
13SEQ14en |
ACEC
ZANUSSI
