Troubleshooting guide
If the DX-R700 begins to operate improperly, use the troubleshooting guide below to help you ascertain the
problem.
Because the unit contains a microcomputer to provide advanced functions, it may malfunction due to
external noise or static electricity. If this happens, disconnect the power cord and then plug it in again after
about 5 seconds.
About the self-diagnosis function
The DX-R700 is equipped with a self-diagnosis function. If a malfunction is detected during operation, one of
the messages given below will appear in the front display.
DisplayCauseRemedy
Disc ErrorY Playback was likely stopped due to dirt,Y Eject the disc and check for dirt, dust,
dust, scratches, or vibrations.and scratches.
Y The disc has been placed inY Eject the disc and check that it is placed
upside down.in correctly.
If you place the disc correctly and the
same message appears, unplug the power
cord and plug it back in again. If the same
message appears again, contact an Onkyo
service representative.
System ErrorA malfunction has occurred in the systemUnplug the power cord and plug it back
(flashing)due to excessive noise or static electricity.in again. If the same message appears
again, contact an Onkyo service
representative.
Messages during recording
DisplayCauseRemedy
Cannot CopyThe input digital signal containsRecord an analog signal or recordable
a copy guard signal (SCMS).music signal (see page 18).
D. In UnlockY The digital input is blocked.Y Verify that the player component is
properly playing and the digital cable is
properly connected (see page 15).
Y Data has been input in theY Verify that source signal is a normal
CD-ROM, etc.music signal (see page 18).
Check LevelThe player component was alreadyStop the player component. Shortly thereafter,
playing.OSignal Wait� will appear (see page 23).
Rec SetupThe DX-R700 is entering theWait until the message disappears.
recording standby state.
RepairAfter recording, the disc was left inWhile ORepair� is displayed, the
the DX-R700 when the power wasDX-R700 is tracing back through the
turned off and the track numbers andrecorded area and repairing the track
recording time data was lost.numbers and recording time data.
When the message disappears,
finalization of the disc is possible.
Depending on the recording amount,
this process may take up to 40 minutes.
Disc FullEither the disc is full of recordings orUse a new disc.
99 tracks have been recorded and no
more recordings can be made on the disc.
43 |
ACEC
ONKYO
