aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
8.Data
Error messagesSpecifications
System:Analog modeling
Data could not be written.
Er.1Number
of parts:2 parts
When writing a song to a different song num-
Er.2Memory
ber, the maximum number of recordable events
capacity:256 patterns, 16 songs
was exceeded. Use the Clear Event operation
to erase unwanted events from the song.
Effects:Distortion, Tempo Delay, Chorus/Flanger
Protect was turned "on" for the memory into
Sequencer:Pattern
Er.9which you attempted to write data. In Global
Maximum 64 steps per part
mode, turn the Protect setting "oFF" (p.40).
Motion sequence
When event-recording on a song, event dataOne parameter for each part, 64 events
memory has filled up. If you attempt to record
FullSong
additional events, the "memory full" message
Maximum 256 patterns per song
will appear immediately. Either use Clear EventMaximum approximately 65,500 events for
to delete unwanted events from a song, orevent recording
record blank data to clear the memory.
Connectors:PHONES
Stereo phone plug
Restoring the factory setNominal level: 21 mW + 21 mW (32 ohms)
OUTPUT (PART1/MIX, PART2)
Phone jacks: mono x 2
data
Nominal output level: -10 dBu
The pattern and song data with which the EA-1 is shipped fromOutput impedance: 1 k-ohms
the factory is referred to as the "preloaded data," and you canAUDIO IN (phone jack: mono x 1)
restore this preloaded data back into the memory of the EA-1.Nominal input level: -10 dBu
When you do this, the patterns you created and the songs whichInput impedance: 47 k-ohms
use these patterns will be erased, and replaced by the preloadedMIDI (IN, OUT, THRU)
data. If you wish to keep the patterns and songs you created,
Power supply: DC 9 V (AC adapter included)
you must save the data on a data filer etc. before you load the
preloaded data.Power consumption:8 W
1. While simultaneously pressing the Transpose key and theDimensions:300 (W) x 222.5 (D) x 53.4 (H) mm
Write key, turn on the power.(with rubber feet)
2. The display will indicate "PLd," and the Play/Pause key willWeight:1.25 kg
blink.
3. To load the factory preloaded data, press the blinking Play/
Pause key.
This will require apporoximately 15 seconds.
To cancel, press the Stop/Cancel key.
When loading is complete, the EA-1 will return to its initial state.
After several seconds the display will indicate pattern number
"A01," and the EA-1 will be in Pattern mode.
Never turn off the power during the Load process. The
data may be damaged.
1
3
Cancel
8.Data
45 |
ACEC
KORG
