aaaaaaaaaaaaaaaaaaaaaaaaa
If something other than OCTAVE is selected for the
12FUNCTION buttonpre-effect, you cannot use the PEDAL FX button to
To edit one of the parameters printed on the front
select OCTAVE.
panel in red, hold down this button and operate the
By holding down the FUNCTION button and pressing
corresponding knob or button. For example, you can
this button, you can select Obank hold� mode as the
edit the speed of the modulation effect by holding
way in which programs will be selected (BANK
down this button and using the MODULATION
HOLD). Refer to OSelecting programs: b� (p.9).
DEPTH buttons.
aaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaa
16Expression pedal
13MASTER (CANCEL) buttons
You can use the expression pedal to control effects
These buttons adjust the overall volume of the
or volume. By advancing the pedal all the way
AX10B (MASTER).
forward you can switch the selected pedal effect on/
When the AX10B is ready to write (store), pressing
off.
either of these buttons will cancel the Write operation
(CANCEL).
17PEDAL LED
This LED will light if the expression pedal is active.
14WRITE button
Use this button to write (store) a program.
18ORIGINAL VALUE LED
When you press this button, the AX10B will enter
This LED will light if the edited value is identical to
Owrite-ready� mode; if you press this button again,
the saved (original) value.
the program will be written (stored). (p.12)
aaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaa
19Program select switches DOWN/BANK DOWN, UP/
15PEDAL FX/BANK HOLD button
BANK UP �BYPASS, TUNE�
This button selects the effect that will be controlled
Use these switches to select programs. You can
by the expression pedal (Pedal Effect).
select programs in one of three ways. Refer to
Each time you press the button, the LED will change
OSelecting programs� (p.9).
color to indicate the pedal effect that will be con-
If you press the UP and DOWN switches simulta-
trolled.
neously, the effects will be bypassed and the tuner
ORG: OCTAVE (orange): Octave
will operate (BYPASS) (p.9).
RED:MOD (red): The effect selected by MODULATION
GRN:AMB (green): The effect selected by AMBIENCE
OFF:VOLUME (dark): Volume pedal
Rear panel
aaaaaaaaaaaaaaaaaaaaaaaaa
20INPUT L/H select switch23AMP/LINE select switch
Set this switch according to the pickup output of yourSet this to OAMP� if you are plugging into an amp, or
bass.to OLINE� if you are plugging into a recorder or using
H: High-output basses with active circuitryheadphones.
L: Low-output bassesIf you are connecting the AX10B to a bass amp that
has a tweeter for extended high-frequency re-
21INPUT jacksponse, select the OLINE� position.
Connect your bass to this jack. Use a 1/4" monoaaaaaaaaaaaaaaaaaaaaaaaaa
plug. If the AX10B is running on batteries, the powerDC9V
24
will come on when you plug into this jack.The separately sold AC adapter can be connected
here (p.8). When this is connected, the power will be
If the AX10B is running on batteries, the power will
not come on if a 1/4" stereo plug is inserted.turned on automatically.
aaaaaaaaaaaaaaaaaaaaaaaaaYou must only use the specified AC adaptor (p.14).
22OUTPUT jack
Connect this jack to your bass amp, recorder, or25Cable hook
headphones.If the separately sold AC adapter is used, connect
the cable of the AC adapter around this hook (p.8).
25 24 20 21 22 23
7 |
ACEC
