aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
4.Pattern mode
Changing the pitchChanging the gate time
PITCHC-1...G9GATE TIME0.25...64.0
1. Turn off the Keyboard function key (the key will go dark).1. Turn off the Keyboard function key (the key will go dark).
2. Use the cursor keys to make the parameter select LEDs indi-2. Use the cursor keys to make the parameter select LEDs indi-
cate PITCH.cate GATE TIME.
3. Use the PART SELECT key to select the part that you wish to3. Use the PART SELECT key to select the part that you wish to
edit.edit.
4. The step keys will light to indicate the trigger locations of the4. The step keys will light to indicate the trigger locations of the
pattern for that part. Press the step key for the step whosepattern for that part. Press the step key for the step whose
pitch you wish to edit (the key will blink). By pressing a stepgate time you wish to edit (the key will blink). By pressing a
key where a trigger exists, you can audition its pitch.step key where a trigger exists, you can audition its pitch.
5. Rotate the dial to modify the pitch of that step.5. Rotate the dial to modify the gate time of that step.
When the display is showing the Pitch, pressing a step key willThe value shown in the display is the gate time length in units
not switch its trigger on/off.of a step. For example if the gate time is set to 1.0, the gate time
Changing the pitch of a step whose trigger is off will have nowill be exactly as long as one step.
effect. If you turn that trigger on, the specified pitch will be
If the gate time length extends into the timing of the next
used. If you wish to transpose the pitch for one part of the en-
note, the filter EG of the next note will not be retriggered.
tire pattern, refer to p.30 "Changing the pitch data of a part (Pitch
Shift)."When the display is showing the Gate Time, pressing a step
key will not switch its trigger on/off.
Changing the gate time of a step whose trigger is off will have
5
no effect. If you turn that trigger on, the specified gate time will
be used.
5
2
3
2
3
4
The pitch will be shown in the display as follows.
4
Display for A3Display for B4Display for D�1
28 |
ACEC
KORG
