EA120.book Seite 11 Mittwoch, 3. März 2004 10:37 10
g
Follow the instructions referring to Making an espresso
decalcification.
After having been brewed, the espresso
Do not immerse the appliance in water.
should be covered with a dense frothy
Safety during repairslayer, the so-called crema.
In the event that the appliance needs To achieve an aromatic espresso with
to be repaired, including changing the crema, fresh, clear water, the correct
electrical cord, send the appliance to size grounds and the water tempera-
the dealer (as the use of special tools is ture are important.
required) from which the appliance
1. Adding water (Figure 2)
was purchased, or to any AEG Cus-
tomer Service centre (see the last page 0 Pull the water tank upwards and out of
for addresses).the appliance (figure 2).
Repairs to electrical appliances may 0 Open the tank lid.
only be carried out by qualified service 0 Fill the water tank with cold, clear
engineers. Improper repairs can give water only.
rise to significant hazards for the user.
Ensure that the water line does not lie
If the appliance is used for purposes below the MIN (minimum) line or
other than those for what it was above the MAX (maximum) line.
intended or is operated wrongly, no lia-0 Close the tank lid.
bility for possible damages can be
0 Replace the water tank and press it
accepted.
downwards so that it is sitting firmly in
This appliance conforms with the the appliance.
;
following EU Directives:
You can also lift the tank lid and fold it
3
73/23/EEC dated 19.02.1973 ?Low
to the side. This enables you to fill the
Voltage Directive?, including
water tank directly when it is in the
Modification Directive 93/68/EEC
appliance, e.g. with a jug.
89/336/EEC dated 03.05.1989 ?EMC
Directive?, including Modification 2. Switching on the appliance
Directive 92/31/EEC0 Switch the appliance on using the on/
off switch (figure 1/A). The power indi-
cator (figure 1/B, red) will illuminate
Prior to using the appliance for
and the temperature indicator
the first time(figure 1/C, green) will start to blink.
Please read the safety instructions in As soon as the operating temperature
order to prevent danger to yourself has been attained, the temperature
and damage to the appliance.indicator light will be on. The tempera-
ture indicator may blink again while
0 Insert the power plug into the power
outlet.the appliance is being used to indicate
that the appliance is re-heating.
Prior to preparing an espresso for the
first time you should rinse out the
heating system once by filling the tank.
Proceed exactly as described in the
section ?Making an espresso? and
?Frothing milk?, but without placing
any ground coffee in the filter. Place a
container that is as large as possible in
the middle of the drip grating
(figure 1/Q) and under the steam noz-
zle (figure 1/F).
11 |
ACEC
AEG
