2. Lift the srgnal arm so it clrcks into the Of ?F position
Ice can still be drspensed. but no more will be made
TIPS
l The drspensers WIII work only with the freezer
door closed.
l The ice dispenser WIII work only If the bin IS
pushed all the way in
l Use only ice crescents tram the ice maker.
Other shapes won?t dispense properly
l When you need more Ice than a glass or
two, scoop it from the bin or remove the bin
The dispenser motor may stop If the dis-
penser bar is held in too long It will be ready
to run again in about 3 minutes.
l Ice stored too long can go stale like water.
Throw it away. 3 Lift the front of the storage bin Pull It out.
l Ice can shrink. Cold moving arr slowly evap- 4 Empty the bin Use hot or warm water to melt the
orates them. If you use ice often, you may ice if necessary. Never use anything sharp to break
never notrce the change. up Ice in the bin. This can damage the brn and
dispenser mechanism.
5. Wash with mild detergent. Rinse well Do not use
harsh or abrastve cleansers or solvents.
Plan to remove and empty the storage bin: 6. When replacing the bin, make sure it IS pushed In
l If the Ice dispenser has not, or will not be used for a all the way. Push the signal arm down to the ON
week or more; position to restart Ice production
l If a power failure causes ice in the bin to melt and
freeze together;
l If the Ice dispenser IS not used regularly
The night light uses a heavy-duty IO-watt bulb It
1 Pull the covering panel out from the bottom and should last about 10,000 hours When it burns out,
slide it to the rear. purchase another from your dealer
7 |
ACEC
WHIRLPOOL
