5. Adjust the legs to level the refrigerator:
Turn the leveling leg to the right to lower that side of the
refrigerator.REFRIGERATOR USE
Turn the leveling leg to the left to raise that side of the
refrigerator.
Ensuring Proper Air Circulation
In order to ensure proper temperature, you need to permit proper
airflow in the refrigerator. As shown in the illustration, cool air
enters through the refrigerator wall and moves down. The air then
recirculates through the vent near the bottom.
6. Check with a level.
7. Open and close the door to make sure it swings properly.
Normal Sounds
Your new refrigerator may make sounds that your old one didn?t
make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, like the floor, walls, and cabinets, can make the sounds
seem louder. The following describes the kinds of sounds and
what may be making them.
Your refrigerator is designed to run more efficiently to keep
your food items at the desired temperatures and to minimize
energy usage. The high efficiency compressor and fans may
cause your refrigerator to run longer than your old one. You
may also hear a pulsating or high-pitched sound from the
compressor or fans adjusting to optimize performance.
Do not block any of these vents with food packages. If the vents
You may hear the evaporator fan motor circulating air throughare blocked, airflow will be prevented, and temperature and
the refrigerator compartment. The fan speed may increase asmoisture problems may occur
you open the doors or add warm food.IMPORTANT: To prevent odors and drying out of food, wrap or
Rattling noises may come from the flow of refrigerant, thecover foods tightly.
water line, or items stored on top of the refrigerator.
Water dripping on the defrost heater during a defrost cycleUsing the Control
may cause a sizzling sound.
As each cycle ends, you may hear a gurgling sound due toSetting the Control
the refrigerant flowing in your refrigerator.
For your convenience, your refrigerator control is preset at the
Contraction and expansion of the inside walls may cause a
popping noise.factory. When you first install your refrigerator, make sure that the
control is still preset to the mid-setting as shown.
You may hear air being forced over the condenser by the
condenser fan.
You may hear water running into the drain pan during the
defrost cycle.
NOTE: To turn your refrigerator off, turn the refrigerator control to
the setting shown. Your product will not cool when the
refrigerator control is set to the off position.
6 |
ACEC
WHIRLPOOL
