Setting electronicallyFilling with salt
(The dishwasher must be switched off)
Special salt can be added in one of two ways:
The dishwasher is factory set at level 5. If itOs necessary to set
a new level, proceed as follows.If you are using dishwasher detergent that already contains
salt, the detergent including the salt is placed in the
detergent compartment.
1.Press the On/Off push button. The indicator lights of the - In this case the water softener must manually be set to 1
programme push buttons will illuminate and in the digital
and electronically to 1 to ensure that the special salt is
display are visible 2 horizontal lines (--) (setting mode).taken from the detergent container only.
2.Press simultaneously function push buttons 2 and 3, the If you are using dishwasher detergent and salt separately,
indicator lights of the function push buttons 1, 2 and 3 start the special salt is to be put into the salt container.
flashing.- In this case the water softener must manually be set to 1
or 2 and electronically between 1 and 10 (depending on
3.Press the function push button 1, the indicator lights of the water hardness in your area) to ensure that the
function push buttons 2 and 3 turn off while the indicator special salt is taken from the salt container only.
light of the push button 1 goes on flashing, the digital
display indicates the current level and a sequence of
intermittent audible signals are heard. Only use salt specifically designed for use in
The current level is indicated by the number visible in the dishwashers.
display and the number of intermittent audible signals All other types of salt not specifically designed for use in
heard.a dishwasher, especially table salt, will damage the water
Example:softener.
Only fill with salt just before starting one of the washing
displayed + 5 audible signals = level 5.
programmes (not the Rinse and Hold programme).
This will prevent any grains of salt or salty water, which
4.To change the level, press push button 1. Each time the may have been spilt, remaining on the bottom of the
push button is pressed the level changes. (For the selection machine for any period of time, which may cause
of the new level see the chart).
corrosion.
Examples:
if the current level is 5, by pressing push button 1 once,
level 6 is selected.To fill:
if the current level is 10, by pressing push button 1 once, 1.Open the door, remove the lower basket and unscrew the
level 1 is selected.cap of the salt container by turning it anticlockwise.
5.To memorise the operation, switch off the dishwasher by 2.Pour 1 litre of water inside the container (this is necessary
only before filling with salt for the first time).
pressing the On/Off push button or wait about 60 seconds
after which the dishwasher will automatically return to 3.Using the funnel provided,
setting mode.pour in the salt until the
container is full.
4.Replace the cap making
sure that there is no trace
of salt on the screw thread
or on the gasket.
5.Screw on the cap tightly
turning it clockwise until it
stops with a click.
The salt container will require topping up periodically. You are
reminded of this by the salt indicator light on the control panel
which comes on when the salt has finished.
Do not worry if water over flows from the unit when filling with
salt, this is quite normal.
The salt indicator light on the control panel can remain
illuminated for 2-6 hours after the salt has been
replenished, assuming the dishwasher remains switched
on. If you are using salts that take longer to dissolve then
this can take longer. The function of the machine is not
affected.
24 |
ACEC
OTHERS
