3. Adjust each leg until the refrigerator won?t rock.
Remove the shipping block. . .
4. Adjust front legs to level the refrigerator.
--I==, A Styrofoam -To raise corners, turn legs clockwise.
# IL
-~ i-L, block IS wedged tn the
Defrost Pan I -To lower corners, turn legs counterclockwise.
defrost pan IO help 6. Check with level.
prevent shipping dam-
age. This block must
be removed to clear Remove sales labels.. .
the way for defrost
Remove the Consumer Buy Guide label, tape and
water, evaporation
any inside labels before using the refrigerator
and to make the
To remove any remaining glue:
Dower cord acces-
Must Be Removed iible. 1 Rub briskly with thumb to make a ball then remove.
OR
2 Soak area with dishwashing detergent solution (1
Install properly.. . teaspoon detergent tn 1 quart warm water] before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
--
Clean your refrigerator m
before using it.
See cleaning Instructions
c on page 7
Plug it in...
1 Allow 3 Inches 7 5 cmj between overhead cab
Inets and tne rrfrlgerotor toC:
2 Allow at least an I~ICP~ (2 5 cm) betweerl the retrIg-
erator condenser and the wall
?? You don t need space between counters and
$zablnets and +r\e cefrlgerator sides For ease of
lnstallotlon, yoo mnlght want tr, leave enough room
I?.? inch ~~ 1 2: ;? mj so the refrigerator can be
moved easily rong
4 If the refrlgeratc r ,s 73 De against 0 wall you mlghr ing plug
wan: +o leave enough space si? the door can be
opermed tilde: Refrigerator
Power Cord
Level refrigerator-freezer... Recommended
Grounding Method
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
ng Leg
and properly grounded electrlcal supply IS re-
qutred It IS recommended that a separate circuit
serving only this appliance be provided
Do not use an extension cord. Use a recep-
Lower tacle which cannot be turned off with a switch
or pull chain. See lndivldual electrical requlre-
1 Keep the 4 bolts that hold refrigerator in shipping
ments and grounding instruction sheet in your Ilter-
crate They are tne levelllng legs
ature package
2 Screw these bolrs all the way Into bolt holes at the
bottom corners of refrigerator Move refrigerator
Into place
4 |
ACEC
WHIRLPOOL
