Install properly.. . Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any inside labels before using the refrigerator
To remove any remaining glue:
I. Rub briskly with thumb to make a ball then remove
OR
2 Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) before
0 removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
r-
I I
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
I/ Clean it.. .
-? A f
Clean your refrigerator before using it. See clean-
1. Allow 3 inches (7.5 cm) between overhead cab-
ing instructions on pages 7 and 8.
inets and the refrigerator top.
2. Allow at least an inch (2.5cm) between the refrig-
erator condenser and the wall.
3. Allow J/Z Inch (1.25 cm) on each side of the re-
Plug it in...
frigerator for ease of installation.
4. If the refrigerator is to be against a wall, you might
want to leave enough space so the door can be
opened wider.
Level refrigerator-freezer.. .
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
1. Keep the 4 bolts that hold refrigerator In shipping A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
crate. They are the levelling legs. and properly grounded electrical supply IS re-
2. Screw these bolts all the way into bolt holes at the quired. It IS recommended that a separate circuit
bottom corners of refrigerator. Roll refrigerator serving only this appliance be provided.
into place. Do not use an extension cord. Use a recep-
3. Lower legs just enough to lift rollers off floor. tacle which cannot be turned off with a switch
4. Adjust each until the refrigerator won?t rock. or pull chain. See individual electrrcal requrre-
5. Adjust front legs to level the refrigerator. ments and grounding instruction sheet in your Irter-
-To raise corners, turn legs counterclockwise. ature package.
-To lower corners, turn legs clockwise.
6. Check with level.
4 |
ACEC
WHIRLPOOL
