Install properly.. . Remove sales labels.. .
Remove the Consumer Buy Guide label. tape and
any inside labels before using the refrrgerator.
To remove any remaining glue:
1 Rub briskly with thumb to make a bail then remove.
OR
2 Soak area with dishwashing detergent solution (1
teaspoon detergent In 1 quart warm water] before
removing glue as descrrbed In step 1.
i DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
3II Do not remove the Tech Sheet fastened under
I I
the refrigerator at the front.
Clean it.. .
m
1 Allow 3 inches (7.5 cm] between overhead cab-
inets and the refrrgerator top.
2. Allow at least an inch (2.5cm) between the refrrg-
erator condenser and the wall Clean your refrigerator before using it See clean-
3. Allow % inch (1.25 cm) on each srde of the re- ing instructrons on pages 7 and 8.
frigerator for ease of installation.
4. If the refrigerator is to be against a wall, you might
want to leave enough space so the door can be
opened wider. Plug it in...
3-prong
grounding type
Level refrigerator-freezer... wall receptacle
Refrigerator
Power Cord
Raise
RECOMMENDED GROUNDING METHOD
This refrigerator has 2 threaded levelling legs that are
shipped in a separate package. A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrical supply IS re-
1. Screw these legs all the way into bolt holes in the
bottom front corners of refrigerator quired It IS recommended that a separate circurt
serving only this appliance be provided
2. Roll the refrigerator into place.
Do not use an extension cord. Use a recep-
3. Lower legs just enough to lift front rollers off floor. tacle which cannot be turned off with a switch
4 Adjust front legs to level the refrigerator or pull chain. See individual electrrcal requlre-
~ To raise corners, turn legs counterclockwise. ments and grounding Instructron sheet in your Irter-
- To lower corners, turn legs clockwise. ature package.
5. Check with level. |
ACEC
WHIRLPOOL
