InstalI properly.. . Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any lnslde labels before using the refrigerator.
To remove any remalnlng glue:
I. Rub briskly with thumb to make a ball then remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachlorlde, etc. These can damage the
materlal.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the retrlgerator at the tront.
Clean it.. .
Clean your refrigerator
before using it.
See cleaning instructions
on page 9.
You don?t need space between counters and
cabinets and the sides and top of the refrigerator.
You might want to leave enough room so the
refrigerator can be rolled easily
The refrigerator back can be flush against the
wall.
If the refrigerator is to be against a wall, you might
want to leave enough space so the door can be J-prong grounding
opened wider. type wall receptacle
4
Level refrigerator-freezer.. .
Front Roller
Refrigerator
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Right to Raise; Do not use an extenslon cord. Use a recep-
Left to Lower tacle which cannot be turned off with a switch
1. Remove base grille (see page 7). or pull chain. See individual electrical require-
2. To raise front, turn each screw to the right. ments and grounding instruction sheet in your liter-
3. To lower front, turn each screw to the left. ature package.
4. Check with level. |
ACEC
WHIRLPOOL
