Install properly.. . Remove sales labels.. .
Remove the Consumer Buy Guide label. tape and
any inside labels before using the refrigerator.
To remove any remaining glue:
I. Rub briskly with thumb to make a bal! then remove
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) before
removrng glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
Clean your refrigerator D - 6 ,,
before using it.
See cleaning tnstructions
on pages 7 and 0.
1. Allow 3 inches (7.5 cm] between overhead cab!-
nets and refrigerator top.
2. Allow at least an inch (2.5 cm] between the
refrigerator condenser on the back and the wall.
3. Allow Y> inch (1.25 cm) on each side of the
refrigerator for ease of installatron. Plug it in...
4. If the refrigerator is to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider
grounding type
wall receptac
Level refrigerator-freezer...
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
This refrigerator has 2 threaded levelling legs that are A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
shipped in a separate package. and properly grounded electrical supply is re-
I, Screw these legs all the way into bolt holes in the quired. It is recommended that a separate circuit
bottom front corners of refrigerator serving only this appliance be provided.
2. Roll the refrigerator into place. Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
3. Lower legs just enough to lift front rollers off floor
or pull chain. See individual electrical require-
4. Adjust front legs to level the refrigerator
ments and grounding instruction sheet in your liter-
- lo raise corners, turn legs counterclockwise.
ature package.
- To lower corners, turn legs clockwise.
5. Check with level.
4 |
ACEC
WHIRLPOOL
