Mid-setting ?4?
Water DispenserREFRIGERATORFREEZER
44
(on some models)
WARNING
IMPORTANT:
Give your refrigerator time to cool down completely before
adding food. It is best to wait 24 hours before you put food
into the refrigerator.
If you add food before the refrigerator has cooled completely,
your food may spoil. Adjusting the Refrigerator and Freezer
Controls to a higher (colder) than recommended setting will
not cool the compartments any faster.
Cut Hazard
Use a sturdy glass when dispensing ice or water.
Adjusting Control Settings
Failure to do so can result in cuts.
The mid-setting(s) indicated in the previous section should be
correct for normal household usage. The controls are set
correctly when milk or juice is as cold as you like and when ice If you did not flush the water system when the refrigerator was
cream is firm. first installed, dispense water into a container until you draw and
discard 2 to 3 gal. (8 to 12 liters) or for approximately 6 to 7
If the temperature is too warm or too cold in the refrigerator or
minutes after the water begins dispensing. The water you draw
freezer, first check the air vents to be sure they are not blocked.
and discard rinses the pipes. Allow several hours for the
If you need to adjust temperatures, use the settings listed in the refrigerator to cool down and chill water.
chart below as a guide. On models with two controls, adjust the
Dispensing Water
refrigerator temperature first. Wait at least 24 hours between
There are two water dispenser buttons as shown for use with
adjustments and then re-check the temperatures.
different sizes of containers.
CONDITION/REASON:ADJUSTMENT:1. Press a glass against the back button or hold a container
under the dispenser while pressing the front button.
REFRIGERATOR section too Adjust REFRIGERATOR
2. Remove the glass or release the front button to stop
warmor TEMPERATURE
dispensing.
Door opened often, large Control one setting
higher NOTE: Dispense enough water every week to maintain a fresh
amount of food added or room
supply.
temperature very warm
FREEZER section too warm/ice Adjust FREEZER or
not made fast enoughTEMPERATURE Control
one setting higher
Door opened often, or large
amount of food added or very
cold room temperature (can?t
cycle often enough)
Heavy ice usage
REFRIGERATOR section Adjust REFRIGERATOR
too coldor TEMPERATURE
Control one setting
Controls not set correctly for
lowerInterior Water Filtration System
your conditions
(on some models)
FREEZER section too coldAdjust FREEZER or
TEMPERATURE Control The interior water filter cartridge is located in the upper corner of Controls not set correctly for
one setting lower the fresh food compartment of the refrigerator. The interior water
your conditions
filter cartridge should be replaced every six months or earlier if
the flow of water to your water dispenser or ice maker decreases
noticeably.
Replacing the interior water filter cartridge
1. Twist the interior water filter cartridge 1D? turn to the left. The
INSTALL mark will be lined up with the indicator line located
on the filter mounting bracket cover.
2. Gently pull down on the cartridge to remove it from the filter
mounting bracket assembly. To prevent water from spilling
inside the refrigerator, DO NOT TIP the cartridge. Dispose of
the cartridge.
12 |
ACEC
WHIRLPOOL
